Infiniti QX4 (R50). Manual — part 370
I
to horn relay terminal 2.
The headlamps flash and the horn sounds intermittently.
The alarm automatically turns off after 50 seconds but will reactivate if the vehicle is tampered with again.
THEFT WARNING SYSTEM DEACTIVATION
NBEL0120S05
To deactivate the theft warning system, a door, the back door or the glass hatch must be unlocked with the
key or remote controller.
When the key is used to unlock the door, smart entrance control unit terminal 30 receives a ground signal
I
from terminal 1 of the LH key cylinder switch
I
from terminal 2 of the back door key cylinder switch.
When the key is used to open the glass hatch, smart entrance control unit terminal 42 receives a ground sig-
nal from terminal 3 of the back door key cylinder switch.
When the smart entrance control unit receives either one of these signals or unlock signal from remote
controller, the theft warning system is deactivated. (Disarmed phase)
PANIC ALARM OPERATION
NBEL0120S06
Multi-remote control system may or may not operate theft warning system (horn and headlamps) as required.
When the multi-remote control system is triggered, ground is supplied intermittently.
I
from smart entrance control unit terminal 4
I
to headlamp relay LH and RH terminal 2 and
I
from terminal 19 of the smart entrance control unit
I
to horn relay terminal 2.
The headlamp flashes and the horn sounds intermittently.
The alarm automatically turns off after 30 seconds or when smart entrance control unit receives any signal
from multi-remote controller.
GI
MA
EM
LC
EC
FE
AT
TF
PD
AX
SU
BR
ST
RS
BT
HA
SC
IDX
THEFT WARNING SYSTEM
System Description (Cont’d)
EL-297
Schematic
NBEL0121
MEL857L
THEFT WARNING SYSTEM
Schematic
EL-298
MEL263M
GI
MA
EM
LC
EC
FE
AT
TF
PD
AX
SU
BR
ST
RS
BT
HA
SC
IDX
THEFT WARNING SYSTEM
Schematic (Cont’d)
EL-299
Wiring Diagram — THEFT —
NBEL0122
FIG. 1
NBEL0122S01
MEL009O
THEFT WARNING SYSTEM
Wiring Diagram — THEFT —
EL-300
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст