Infiniti QX4 (R50). Manual — part 73
SAT999A
13. Remove converter housing from transmission case.
I
Be careful not to scratch converter housing.
SAT995A
14. Remove O-ring from input shaft.
SAT027B
15. Remove oil pump assembly.
a.
Attach Tool to oil pump assembly and extract it evenly from
transmission case.
SAT028B
b.
Remove O-ring from oil pump assembly.
c.
Remove traces of sealant from oil pump housing.
I
Be careful not to scratch pump housing.
SAT108B
d.
Remove needle bearing and thrust washer from oil pump
assembly.
GI
MA
EM
LC
EC
FE
TF
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
DISASSEMBLY
AT-289
SAT988A
16. Remove input shaft and oil pump gasket.
SAT029B
17. Remove brake band and band strut.
a.
Loosen lock nut and remove band servo anchor end pin from
transmission case.
SAT986A
b.
Remove brake band and band strut from transmission case.
SAT655
c.
Hold brake band in a circular shape with clip.
SAT030B
18. Remove front side clutch and gear components.
a.
Remove clutch pack (reverse clutch, high clutch and front sun
gear) from transmission case.
DISASSEMBLY
AT-290
SAT113B
b.
Remove front bearing race from clutch pack.
c.
Remove rear bearing race from clutch pack.
SAT031B
d.
Remove front planetary carrier from transmission case.
SAT968A
e.
Remove front needle bearing from front planetary carrier.
f.
Remove rear bearing from front planetary carrier.
SAT974A
g.
Remove rear sun gear from transmission case.
SAT546J
19. Remove rear extension assembly (2WD model only).
a.
Remove rear extension assembly.
b.
Remove parking gear and needle bearing.
CAUTION:
Insert your hand between rear extension and transmission
case. Detach rear extension assembly while holding parking
gear and needle bearing by hand.
c.
Remove rear extension gasket.
GI
MA
EM
LC
EC
FE
TF
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
DISASSEMBLY
AT-291
SAT755I
20. Remove adapter case (4WD model only).
a.
Remove adapter case from transmission case.
b.
Remove adapter case gasket from transmission case.
SAT756I
c.
Remove oil seal from adapter case.
I
Be careful not to scratch adapter case.
I
Do not remove oil seal unless it is to be replaced.
SAT556J
21. Remove revolution sensor from rear extension or adapter
case.
a.
Remove O-ring from revolution sensor.
SAT960A
22. Remove output shaft and parking gear (4WD model only).
a.
Remove rear snap ring from output shaft.
SAT957A
b.
Slowly push output shaft all the way forward.
I
Do not use excessive force.
c.
Remove snap ring from output shaft.
DISASSEMBLY
AT-292
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст