Infiniti QX4 (R50). Manual — part 505
2WD, 4WD model
8.5
(9 US qt, 7-1/2 Imp qt)
Drain plug:
: 29 - 39 N·m (3.0 - 4.0 kg-m, 22 - 29 ft-lb)
4.
Run engine at idle speed for five minutes.
5.
Check fluid level and condition. Refer to MA-21, “Checking A/T
Fluid”. If fluid is still dirty, repeat steps 2 through 5.
SMA439B
Checking All-mode 4WD Transfer Fluid
NBMA0022
Check for oil leakage and fluid level.
A/T fluid is used for the all-mode 4WD transfer in the factory.
Never start engine while checking fluid level.
Filler plug:
: 10 - 20 N·m (1.0 - 2.0 kg-m, 87 - 174 in-lb)
SMA444B
Changing All-mode 4WD Transfer Fluid
NBMA0023
When changing all-mode 4WD transfer fluid completely, A/T fluid
may be used.
Fluid grade:
Nissan Matic “D” (Continental U.S. and Alaska) or
Canada NISSAN Automatic Transmission Fluid.
Refer to “Fluids and Lubricants”, “RECOMMENDED
FLUIDS AND LUBRICANTS”, MA-11.
Fluid capacity:
3.0
(3-1/8 US qt, 2-5/8 Imp qt)
Drain plug:
: 10 - 20 N·m (1.0 - 2.0 kg-m, 87 - 174 in-lb)
CHASSIS AND BODY MAINTENANCE
Changing A/T Fluid (Cont’d)
MA-22
SMA231
SMA872C
Checking Propeller Shaft
NBMA0024
Check propeller shaft for damage, looseness or grease leakage.
Tightening torque: Refer to PD-4, “Components”.
SMA873C
Greasing Propeller Shaft
NBMA0025
Apply specified grease to nipples provided on propeller shaft.
Grease grade:
Refer
to
“RECOMMENDED
FLUIDS
AND
LUBRICANTS”, MA-11.
SMA440B
Checking Differential Gear Oil
NBMA0026
Check for oil leakage and oil level.
Filler plug:
Front
: 39 - 59 N·m (4 - 6 kg-m, 29 - 43 ft-lb)
Rear
: 59 - 118 N·m (6 - 12 kg-m, 43 - 87 ft-lb)
GI
EM
LC
EC
FE
AT
TF
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
CHASSIS AND BODY MAINTENANCE
Checking Propeller Shaft
MA-23
SMA632C
SMA631C
Changing Differential Gear Oil
NBMA0027
1.
Drain oil from drain plug and refill with new gear oil.
2.
Check oil level.
Oil grade and viscosity:
See “RECOMMENDED FLUIDS AND LUBRICATNS”,
MA-11, 12.
Oil capacity:
Front
1.85
(3-7/8 US pt, 3-1/4 Imp pt)
Rear
2.8
(5-7/8 US pt, 4-7/8 Imp pt)
Filler plug:
Front
: 39 - 59 N·m (4 - 6 kg-m, 29 - 43 ft-lb)
Rear
: 59 - 118 N·m (6 - 12 kg-m, 43 - 87 ft-lb)
Drain plug:
Front
: 59 - 98 N·m (6 - 10 kg-m, 43 - 72 ft-lb)
Rear
: 59 - 118 N·m (6 - 12 kg-m, 43 - 87 ft-lb)
LIMITED-SLIP DIFFERENTIAL GEAR
NBMA0027S01
I
Use only approved limited-slip differential gear oil.
I
Limited-slip differential identification.
1.
Lift both rear wheels off the ground.
2.
Turn one rear wheel by hand.
3.
If both rear wheels turn in the same direction simultaneously,
vehicle is equipped with limited-slip differential.
Balancing Wheels
NBMA0028
Adjust wheel balance using the road wheel center.
Wheel balance (Maximum allowable unbalance):
Refer to SDS, MA-29.
SGI991
Tire Rotation
NBMA0029
I
After rotating the tires, adjust the tire pressure.
I
Retighten the wheel nuts after the vehicle has been driven
for 1,000 km (600 miles). (also in cases of a flat tire, etc.)
Wheel nuts:
: 118 - 147 N·m (12 - 15 kg-m, 87 - 108 ft-lb)
CHASSIS AND BODY MAINTENANCE
Changing Differential Gear Oil
MA-24
SBR451D
Checking Brake Fluid Level and Leaks
NBMA0030
If fluid level is extremely low, check brake system for leaks.
SBR389C
Checking Brake Lines and Cables
NBMA0031
Check brake fluid lines and parking brake cables for improper
attachment, leaks, chafing, abrasions and deterioration.
SMA260A
Checking Disc Brake
NBMA0032
ROTOR
NBMA0032S01
Check condition and thickness.
Standard thickness:
28 mm (1.10 in)
Minimum thickness:
26 mm (1.02 in)
SMA922A
CALIPER
NBMA0032S02
Check for leakage.
SMA847B
PAD
NBMA0032S03
Check wear or damage.
Standard thickness:
11 mm (0.43 in)
Minimum thickness:
2 mm (0.08 in)
GI
EM
LC
EC
FE
AT
TF
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
CHASSIS AND BODY MAINTENANCE
Checking Brake Fluid Level and Leaks
MA-25
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст