Infiniti Q45. Manual — part 6
LASER BEAM AIMING ADJUSTMENT
ACS-17
[ICC]
C
D
E
F
G
H
I
J
L
M
A
B
ACS
6.
Touch “LASER BEAM ADJUST” on “SELECT WORK ITEM”
screen.
7.
Touch “START”.
CAUTION:
If the adjustment screen does not appear on the CONSULT-
II screen in 10 seconds. After touching “LASER BEAM
ADJUST” screen, the following causes may be considered:
●
Target is not set accurately.
●
There is not enough space beside the target.
●
The range of laser beam aiming exceeds for improper
installation position.
–
Deformation of vehicle body.
–
Deformation of unit.
–
Deformation of bracket.
●
The area is not suitable for the adjustment work.
●
ICC sensor is not clean.
8.
After the CONSULT-II displays “ADJUST THE VERTICAL OF
LASER BEAM AIMING” turn the up-down direction adjusting
screw until “U/D CORRECT” value is set in the range of
±
4.
CAUTION:
Turn the screw slowly. The value change on display is
slower than actual movement of the ICC sensor. Wait for 2
seconds every time the screw is turned half a rotation.
NOTE:
Turning the screw clockwise to laser beam is downward and
counterclockwise to laser beam is upward.
9.
When “U/D CORRECT” value indicates
±
4, confirm that the margin of value remains within
±
4 at least for
2 seconds with no equipment or hand touching the ICC sensor.
SKIA6191E
SKIA1220E
SKIA1221E
PKIA9671E
ACS-18
[ICC]
LASER BEAM AIMING ADJUSTMENT
When “COMPLETED THE VERTICAL AIMING OF LASER
BEAM” appears on screen, touch “END”.
CAUTION:
Be sure that the margin of “U/D CORRECT” is within
±
4 with
ICC sensor unit is untouched.
10. Confirm that “ADJUSTING AUTOMATIC HORIZONTAL LASER
BEAM AIMING” is on screen and wait for a while. (maximum: 10
seconds.)
11. Confirm that “NORMALLY COMPLETED” is displayed on CON-
SULT-II and close the aiming adjustment procedure by touching
“END”.
CAUTION:
Complete all the procedures once “LASER BEAM ADJUST”
mode is entered in CONSULT-II. When the procedure is dis-
continued, the ICC system is inoperable.
CHECK AFTER THE ADJUSTMENT
Test the ICC system operation by running test. Refer to
ACS-11, "ICC System Running Test"
.
SKIA1223E
SKIA1224E
SKIA1225E
ELECTRICAL UNITS LOCATION
ACS-19
[ICC]
C
D
E
F
G
H
I
J
L
M
A
B
ACS
ELECTRICAL UNITS LOCATION
PFP:25230
Component Parts and Harness Connector Location
NKS001K5
PKIC5176E
ACS-20
[ICC]
WIRING DIAGRAM
WIRING DIAGRAM
PFP:00000
Schematic
NKS001K6
TKWM3833E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст