Infiniti Q45. Manual — part 904
TROUBLE DIAGNOSIS
WT-25
C
D
F
G
H
I
J
K
L
M
A
B
WT
Transmitter Wake Up Operation
NES000HF
WITH ACTIVATION TOOL
1.
With the transmitter activation tool (J-45295) pushed against the
front-left transmitter, press and hold the button for 5 seconds.
●
When ignition switch ON, and then low tire pressure warning
lamp blinks as per the following diagram, the respective then
transmitter must be wake up.
2.
Register the ID of wheel that low tire pressure warning lamp flashes. When wake up of registered wheel
has been completed, hazard warning lamp flashes two times.
3.
After completing wake up all transmitters, make sure low tire pressure warning lamp goes out.
SEIA0460E
SEIA0762E
WT-26
TROUBLE DIAGNOSIS
Inspections Before Trouble Diagnosis
NES000D0
DIAGNOSTIC PROCEDURE
1.
CHECK ALL TIRE PRESSURES
Check all tire pressures. Refer to
OK or NG
OK
>> GO TO 2.
NG
>> Check the condition of wheels (flat tire etc.). Then, adjust tire pressure to the specified value.
2.
CHECK LOW TIRE PRESSURE WARNING LAMP
●
Turn ignition switch “OFF”.
●
Check low tire pressure warning lamp “ON” for approx. 1 second when turned ignition switch “ON”.
Dose low tire pressure warning lamp “ON” for approx. 1 second?
YES
>> GO TO 3.
NO
>> Go to
WT-40, "Low Tire Pressure Warning Lamp Does Not Turn ON for Approx.1 Second When
3.
CHECK LOW TIRE PRESSURE WARNING CONTROL UNIT HARNESS CONNECTOR
1.
Disconnect low tire pressure warning control unit harness connector.
2.
Check low tire pressure warning control unit pin terminals for damage or loose connection with harness
connector.
OK or NG
OK
>> GO TO 4.
NG
>> Repair or replace damaged parts.
4.
CHECK DTC
Drive at a speed of 40 km/h (25 MPH) or more for several minutes without stopping after perform self-diagno-
sis. Refer to
WT-21, "Self-Diagnostic Procedure"
.
OK or NG
OK
>> INSPECTION END
NG
>> Perform the self-diagnosis, inspect detected malfunction.
Trouble Diagnosis Chart for Symptoms
NES000D3
If low tire pressure warning lamp turns ON, perform self-diagnosis. Refer to
WT-21, "Self-Diagnostic Procedure"
Symptom
Condition
Check item
Reference page
Low tire pressure warning lamp does not
turn ON for approx.1 second when ignition
switch is turned ON.
Ignition ON
Power supply and ground for low tire
pressure warning control unit
Combination meter
Low tire pressure warning lamp stays ON
when ignition switch is turned ON.
Ignition ON
Power supply and ground for low tire
pressure warning control unit
Combination meter
Low tire pressure warning lamp blinks when
ignition switch is turned ON.
Ignition ON
Tire pressure warning check switch
Hazard warning lamp blinks when ignition
switch is turned ON.
Ignition ON
Combination flasher unit
“TIRE PRESSURE” information in display
does not exist.
Ignition ON
Power supply
Display circuit
ID registration cannot be completed.
Engine running
Transmitter wake up
ID registration
Transmitter
TROUBLE DIAGNOSIS
WT-27
C
D
F
G
H
I
J
K
L
M
A
B
WT
Low Tire Pressure Warning Lamp Symptom Chart
NES000DN
Diagnosis
Item
Symptom
(Ignition switch “ON”)
Low tire pressure warning lamp
Cause
Action
Low tire pres-
sure warning
lamp
Warning light comes
on immediately and
turns off after 1 sec-
ond.
All wheel transmit-
ters are “activated”
(working).
None (system OK)
Warning light blinks
on for 2 seconds,
then turns off for 0.2
seconds-repeats.
All wheel transmit-
ters are not acti-
vated.
Activate all wheel transmit-
ters. Refer to
"Transmitter Wake Up Oper-
ation"
Warning light blinks 1
time.
Front LH wheel
transmitter is not
activated.
Activate front LH wheel
transmitter. Refer to
"Transmitter Wake Up Oper-
ation"
Warning light blinks 2
times.
Front RH wheel
transmitter is not
activated.
Activate front RH wheel
transmitter. Refer to
"Transmitter Wake Up Oper-
ation"
Warning light blinks 3
times.
Rear RH wheel
transmitter is not
activated.
Activate rear RH wheel
transmitter. Refer to
"Transmitter Wake Up Oper-
ation"
SEIA0592E
SEIA0593E
PEIA0073E
SEIA0595E
SEIA0596E
WT-28
TROUBLE DIAGNOSIS
NOTE:
If more than one wheel transmitter is NOT activated, the warning light blinking patterns for those wheels will combine. (Example: one
blink/“OFF”/three blinks = Rear LH and Rear RH transmitters are not activated.)
Low tire pres-
sure warning
lamp
Warning light blinks 4
times.
Rear LH wheel trans-
mitter is not acti-
vated.
Activate rear LH wheel
transmitter. Refer to
"Transmitter Wake Up Oper-
ation"
Warning light comes
on and does not turn
off.
Tire pressure is low.
Check tire pressure with
CONSULT-II. Refer to
The fuse for combi-
nation meter from
battery is pulled out.
Check the fuse for combina-
tion meter from battery.
Install or replace (if needed).
Low tire pressure
warning control unit
connector pulled out.
Check low tire pressure
warning control unit connec-
tor. Re-connect if needed.
Low tire pressure or
low tire pressure
warning system mal-
function.
●
Perform CONSULT-II
Self-Diagnosis. Refer to
WT-19, "SELF-DIAG
RESULT MODE"
.
–
Perform ID Registration if
needed. Refer to
Turn signal
lamp
Turn signal lamp
does not flash 2
times or buzzer does
not sound after trans-
mitter activation.
—
1. Tool J-45295 (spe-
cial service tool) bat-
tery low.
1. Install new battery.
2. Ignition “OFF” dur-
ing activation.
2. Make sure ignition is “ON”
during activation.
3. Tool No. J-45295
(special service tool)
not positioned cor-
rectly.
3. Position tool correctly dur-
ing activation.
4. Transmitters
already activated.
4. None
Diagnosis
Item
Symptom
(Ignition switch “ON”)
Low tire pressure warning lamp
Cause
Action
SEIA0597E
SEIA0598E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст