Infiniti Q45. Manual — part 529
VARIABLE INDUCTION AIR CONTROL SYSTEM (VIAS)
EC-755
C
D
E
F
G
H
I
J
K
L
M
A
EC
6.
CHECK VIAS CONTROL SOLENOID VALVE POWER SUPPLY CIRCUIT
1.
Turn ignition switch OFF.
2.
Disconnect VIAS control solenoid valve harness connector.
3.
Turn ignition switch ON.
4.
Check voltage between VIAS control solenoid valveterminal 1
and ground with CONSULT-II or tester.
OK or NG
OK
>> GO TO 8.
NG
>> GO TO 7.
7.
DETECT MALFUNCTIONING PART
Check the following.
●
Harness connectors M135, F105
●
Harness continuity between VIAS control solenoid valve and ECM relay
>> Repair open circuit or short to ground or short to power in harness or connectors.
8.
CHECK VIAS CONTROL SOLENOID VALVE OUTPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
1.
Turn ignition switch OFF.
2.
Disconnect ECM harness connector.
3.
Check harness continuity between ECM terminal 29 and terminal 2.
Refer to Wiring Diagram.
4.
Also check harness for short to ground and short to power.
OK or NG
OK
>> GO TO 9.
NG
>> Repair open circuit or short to ground or short to power in harness or connectors.
9.
CHECK VIAS CONTROL SOLENOID VALVE
Refer to
EC-756, "Component Inspection"
OK or NG
OK
>> GO TO 10.
NG
>> Replace VIAS control solenoid valve.
PBIB2421E
Voltage: Battery voltage
PBIB0173E
Continuity should exist.
EC-756
VARIABLE INDUCTION AIR CONTROL SYSTEM (VIAS)
10.
CHECK INTERMITTENT INCIDENT
Refer to
EC-145, "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT"
.
>> INSPECTION END
Component Inspection
NBS0026X
VIAS CONTROL SOLENOID VALVE
With CONSULT-II
1.
Reconnect harness connectors disconnected.
2.
Turn ignition switch ON.
3.
Perform “VIAS SOL VALVE” in “ACTIVE TEST” mode.
4.
Check air passage continuity and operation delay time under the
following conditions.
Operation takes less than 1 second.
Without CONSULT-II
Check air passage continuity and operation delay time under the fol-
lowing conditions.
Operation takes less than 1 second.
VACUUM TANK
1.
Disconnect vacuum hose connected to vacuum tank.
2.
Connect a vacuum pump to the port A of vacuum tank.
3.
Apply vacuum and make sure that vacuum exists at the port B.
Removal and Installation
NBS0026Y
VIAS CONTROL SOLENOID VALVE
Refer to
Condition
VIAS SOL VALVE
Air passage continuity
between A and B
Air passage continuity
between A and C
ON
Yes
No
OFF
No
Yes
PBIB0177E
Condition
Air passage continuity
between A and B
Air passage continuity
between A and C
12V direct current supply
between terminals 1 and 2
Yes
No
No supply
No
Yes
MEC488B
PBIB0846E
MIL AND DATA LINK CONNECTOR
EC-757
C
D
E
F
G
H
I
J
K
L
M
A
EC
MIL AND DATA LINK CONNECTOR
PFP:24814
Wiring Diagram
NBS00281
TBWM1261E
EC-758
MIL AND DATA LINK CONNECTOR
TBWM1262E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст