Infiniti Q45. Manual — part 95
REPAIR FOR COMPONENT PARTS
AT-293
D
E
F
G
H
I
J
K
L
M
A
B
AT
INSPECTION
Check the following, and replace high and low reverse clutch assembly if necessary.
High and Low Reverse Clutch Snap Ring
Check for deformation, fatigue or damage.
High and Low Reverse Clutch Drive Plates
Check facing for burns, cracks or damage.
High and Low Reverse Clutch Retaining Plate and Driven Plates
Check facing for burns, cracks or damage.
ASSEMBLY
1.
Install drive plates, driven plates and retaining plate in high and
low reverse clutch drum.
●
Snap ring (1)
●
Retaining plate (2)
●
Drive plate (3)
●
Driven plate (4)
●
Drive plate/Driven plate: 5/5
CAUTION:
Take care with order of plates.
2.
Using a flat-bladed screwdriver, install snap ring in high and low
reverse clutch drum.
3.
Install bearing race to high and low reverse clutch drum.
CAUTION:
Apply petroleum jelly to bearing race.
SCIA7134E
SCIA2868E
SCIA5215E
AT-294
REPAIR FOR COMPONENT PARTS
Direct Clutch
NCS0011N
COMPONENTS
DISASSEMBLY
1.
Using a flat-bladed screwdriver, remove snap rings from direct
clutch drum.
2.
Remove drive plates, driven plates, dish plate and retaining
plate from direct clutch drum.
INSPECTION
Check the following, and replace direct clutch assembly if necessary.
Direct Clutch Snap Ring
Check for deformation, fatigue or damage.
Direct Clutch Drive Plates and Driven Plates
Check facing for burns, cracks or damage.
Direct Clutch Retaining Plate and Dish Plate
Check facing for burns, cracks or damage.
1.
Direct clutch drum
2.
Driven plate
3.
Retaining plate
4.
Snap ring
5.
Drive plate
6.
Dish plate
SCIA6983E
SCIA2868E
REPAIR FOR COMPONENT PARTS
AT-295
D
E
F
G
H
I
J
K
L
M
A
B
AT
ASSEMBLY
1.
Install drive plates, driven plates, dish plate and retaining plate
in direct clutch drum.
●
Snap ring (1)
●
Retaining plate (2)
●
Drive plate (3)
●
Driven plate (4)
●
Dish plate (5)
●
Drive plate/Driven plate: 6/6
CAUTION:
Take care with order of plates.
2.
Using a flat-bladed screwdriver, install snap rings in direct clutch
drum.
SCIA6951E
SCIA2868E
AT-296
ASSEMBLY
ASSEMBLY
PFP:00000
Assembly (1)
NCS0011O
1.
As shown in the figure, use a drift [commercial service tool: 22
mm (0.87 in) dia.] to drive manual shaft oil seals into the trans-
mission case until it is flush.
CAUTION:
●
Do not reuse manual shaft oil seals.
●
Apply ATF to manual shaft oil seals.
2.
Install detent spring and spacer in transmission case.
3.
Install manual shaft to transmission case.
4.
Install parking rod to manual plate.
SCIA5259E
: 7.9 N·m (0.81 kg-m, 70 in-lb)
SCIA5248E
SCIA5716E
SCIA5220E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст