Infiniti Q45. Manual — part 764
SUNROOF
RF-21
C
D
E
F
G
H
J
K
L
M
A
B
RF
GAP ADJUSTMENT
1.
Open sun shade.
2.
Tilt glass lid up and then remove side trims.
3.
Loosen glass lid securing nuts (2 each on left and right sides), then tilt glass lid down.
4.
Adjust glass lid from outside of vehicle so it resembles “A – A” as shown in the figure above.
5.
Tilt glass lid up and down until it is adjusted to “C – C” as shown in the figure above.
6.
After adjusting glass lid, tilt glass lid up and then tighten nuts.
7.
Tilt glass lid up and down several times to check that it moves smoothly.
HEIGHT DIFFERENCE ADJUSTMENT
1.
Tilt glass lid up and down.
2.
Check height difference between roof panel and glass lid to see
if it is as “A – A” as shown in the figure above.
3.
If necessary, adjust it by using one of following procedures.
●
Adjust by adding or removing adjustment shim(s) between glass
lid and link assembly.
●
If glass lid protrudes above roof panel, add shim(s) or plain
washer at sunroof mounting bracket or stud bolt locations to
adjust sunroof installation as required.
Removal and Installation
NIS0010Y
●
After any adjustment, check sunroof operation and lid alignment.
●
Handle finisher plate and glass lid with care so not to cause damage.
●
It is desirable for easy installation to mark each point before removal.
CAUTION:
●
Always work with a helper.
SIIA0276E
RF-22
SUNROOF
●
Fully close the glass lid assembly, before removal, then do not operate motor assembly after
removal.
SIIA0277E
SUNROOF
RF-23
C
D
E
F
G
H
J
K
L
M
A
B
RF
SUNROOF UNIT
Removal
CAUTION:
●
Always work with a helper.
●
When taking sunroof unit out, use clothes to protect the seats and trim from damage.
●
After installing the sunroof unit and glass lid, be sure to carry out the leak test and check that
there is no malfunction.
1.
Remove the headlining. Refer to
EI-58, "Removal and Installation"
2.
Disconnect drain hoses.
3.
4.
Remove screws, then remove the sunroof switch bracket.
5.
Remove motor mounting screws. Disconnect connector from
sunroof motor and then remove sunroof motor.
CAUTION:
●
Before removing sunroof motor, make sure that sunroof
lid is fully closed.
●
After removing sunroof motor, do not attempt to rotate
sunroof motor as a single unit.
6.
Remove nuts from the front end and side rail.
7.
Remove side curtain air bag bracket bolts. Refer to
SRS-46, "SIDE CURTAIN AIR BAG MODULE"
SIIA0275E
SIIA0274E
SIIA0273E
RF-24
SUNROOF
8.
Remove bolts, and then remove assist grip bracket.
9.
Remove front sunroof bracket bolts.
10. Remove rear sunroof bracket bolts, and then remove sunroof
unit from roof panel.
11. Remove sunroof unit through the passenger compartment while being careful not to damage the seats
and trim.
Installation
1.
Temporarily tighten the mounting bolts to the rear sunroof brack-
ets (RH/LH).
PIIB1774E
SIIA0272E
SIIA0271E
SIIA0270E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст