Infiniti Q45. Manual — part 216
AUTO TRUNK SYSTEM
BL-133
C
D
E
F
G
H
J
K
L
M
A
B
BL
AUTO TRUNK SYSTEM
PFP:98841
Outline of System
NIS000W5
●
Operating trunk button (on electronic key) or trunk lid opener switch (under the driver door armrest) allows
trunk lid auto OPEN operation. Also, operating trunk lid close switch (inside the trunk lid) allows trunk lid
auto CLOSE operation.
●
If any pinched foreign material is detected during auto CLOSE operation, the anti-pinch mechanism stops
trunk lid from closing and shifts the operation to manual.
●
The buzzer sounds when trunk lid auto operation starts (operation start buzzer).
●
The buzzer sounds during trunk lid auto CLOSE operation (warning buzzer).
OPERATING CONDITION
Any of the following operations during trunk lid auto operation stops the auto operation and shifts the operation
to manual. Moving trunk lid manually to a position just before fully closed position activates the auto closure
mechanism to close trunk lid completely.
●
When trunk lid opener switch is operated.
●
When trunk lid close switch is operated.
●
When trunk button on electronic key is operated (at least 0.5 seconds).
●
When selector lever is shifted to a position other than “P” position (detention switch: ON).
●
When vehicle speed becomes 7 km/h or higher.
●
When auto operation does not end after 10 seconds since the start.
●
With trunk lid position falls within ranges A and B in the figure,
when trunk lid stops auto operation forcefully or because of
pinched foreign material.
Removal and Installation
NIS000W6
PRECAUTIONS FOR WORK
●
During removal and installation, be careful not to allow any
grease to adhere to the solenoid clutch joint (A in the figure).
●
If grease adheres to the solenoid clutch joint (A in the figure),
clutch becomes slippery and generates a transmission loss
resulting in inactive auto operation.
PIIA0510E
SIIA0759E
BL-134
AUTO TRUNK SYSTEM
REMOVAL
1.
Open trunk lid.
2.
Remove rear parcel shelf finisher. Refer to
EI-48, "REAR PARCEL SHELF FINISHER"
.
3.
Remove trunk motor assembly mounting bolts and nut.
4.
Remove trunk front finisher and trunk side finisher (LH). Refer to
EI-60, "TRUNK ROOM TRIM & TRUNK
5.
Disconnect trunk motor connector.
6.
Remove main arm mounting nut on trunk lid hinge.
7.
Remove mounting bolt and nut, and remove trunk motor assem-
bly.
INSTALLATION
Install in reverse order of removal.
CAUTION:
Be careful not to pinch the harnesses. Be sure to check operation after installation is completed.
PIIA0130E
PIIA0131E
AUTO TRUNK SYSTEM
BL-135
C
D
E
F
G
H
J
K
L
M
A
B
BL
Component Installation Location
NIS000W7
PIIB7921E
BL-136
AUTO TRUNK SYSTEM
Schematic
NIS000W8
TIWM0406E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст