Infiniti Q45. Manual — part 534
FRONT BUMPER
EI-15
C
D
E
F
G
H
J
K
L
M
A
B
EI
REMOVAL
1.
Release front air cover clips, and remove front air guide.
2.
Remove front grille. Refer to
3.
Remove bolts at the edge of engine undercover.
4.
Remove bolts and clips of both front fender protectors (LH/RH). (on front side)
5.
Remove screws from both front fenders (LH/RH).
6.
Remove clips from upper bracket assembly.
7.
Disconnect bumper fascia from bumper clips.
7.
Clip (C103)
8.
Bumper molding (RH)
9.
Bumper fascia
10. Fog lamp (RH)
11.
Bumper grille (RH)
12. License plate bracket
13. Bumper grille (left)
14. Fog lamp (LH)
15. Bumper molding (LH)
16. U nut
17. ACC finisher
18. Clip (C205)
19. Nut
20. Bolt
21. ACC
22. Bumper stay (LH)
23. Bumper fin (RH)
24. Bumper fin (LH)
PIIA9401E
PIIB1681E
PIIB1682E
EI-16
FRONT BUMPER
8.
Disconnect fog lamp harness connectors (LH/RH).
9.
Remove bumper fascia assembly.
CAUTION:
When removing bumper fascia, 2 workers are required so as to prevent it from dropping.
10. Remove bumper fin (LH/RH).
11. Disengage clips, and remove bumper grille (LH/RH).
12. Disengage clips, and remove ACC finisher.
13. Remove license plate bracket bolts, and remove licence plate bracket.
14. Remove bumper molding (LH/RH).
15. Remove fog lamp (LH/RH). Refer to
16. Remove bumper energy absorber.
17. Remove bumper reinforcement nuts, and remove bumper reinforcement assembly.
18. Remove bumper stay nuts/bolts, and remove bumper stay
assembly (LH/RH).
PIIB1683E
PIIB1685E
PIIB1686E
PIIB1684E
FRONT BUMPER
EI-17
C
D
E
F
G
H
J
K
L
M
A
B
EI
INSTALLATION
Install in the reverse order of removal.
NOTE:
After installing, perform fitting adjustment.
EI-18
REAR BUMPER
REAR BUMPER
PFP:H5022
Removal and Installation
NIS00119
CAUTION:
Bumper fascia is made of resin; do not apply pressure to or let oils contact its surface.
1.
Nut
2.
Bolt
3.
Bumper stay (LH)
4.
Rear wheelhouse protector (LH)
5.
Clip (CF110)
6.
Bumper reinforcement
PIIB1687E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст