Infiniti Q45. Manual — part 316
VEHICLE INFORMATION AND INTEGRATED SWITCH SYSTEM /WITHOUT
NAVIGATION SYSTEM
DI-131
C
D
E
F
G
H
I
J
L
M
A
B
DI
CONFIRMATION/ADJUSTMENT MODE
Operation Procedure
1.
Start the engine.
2.
Turn the audio system off.
3.
While pressing the “INFO” switch, turn the volume control dial
clockwise or counterclockwise for 30 clicks or more. (When the
self-diagnosis mode is started, a short beep will be heard.)
●
Shifting from current screen to previous screen is performed
by pressing “PREV” switch.
4.
The initial trouble diagnosis screen will be shown, and items
“Self Diagnosis” and “Confirmation/Adjustment” will become
selective.
5.
When “Confirmation/Adjustment” is selected on the initial trouble
diagnosis screen, the operation will enter the CONFIRMATION/
ADJUSTMENT mode. In this mode, check and adjustment of
each item will become possible.
6.
Select each switch on “Confirmation/Adjustment” screen to dis-
play the relevant diagnosis screen.
Display Diagnosis
PKIB0256E
SKIA0381E
SKIA5028E
SKIB0796E
DI-132
VEHICLE INFORMATION AND INTEGRATED SWITCH SYSTEM /WITHOUT
NAVIGATION SYSTEM
CAUTION:
When DISPLAY COLOR SPECTRUM BAR screen is completed after “PREV” switch is pressed, the
screen color changes once. This is normal.
●
When RGB signal error occurred in the RGB system, tone of the color bar will change as follows.
●
When the color of the screen looks unusual, refer to
DI-142, "Color of RGB Image Is Not Proper"
Vehicle Signals
●
A comparison check can be made of each actual vehicle signal
and the signals recognized by the system.
Rear View Camera
Refer to
DI-185, "Side Distance Guideline Correction"
Auto Climate Control
Refer to
ATC-53, "Self-diagnosis Function"
in ATC section for the details.
Speaker Test
Refer to
AV-40, "Confirmation/Adjustment Mode"
for the details.
CONSULT-II Function (MULTI AV)
NKS001CP
CONSULT-II can display each diagnostic item using the diagnostic test modes shown following.
R (red) signal error
: Screen looks bluish
G (green) signal error
: Screen looks yellowish
B (blue) signal error
: Screen looks reddish
PKIA9684E
Diagnosis item
Display
Condition
Remarks
Vehicle Speed
ON
Vehicle speed > 0 km/h (0 MPH)
Changes in indication may be delayed by
approx. 1.5 seconds. This is normal.
OFF
Vehicle speed = 0 km/h (0 MPH)
–
Ignition switch in ACC position
Light
ON
Lighting switch ON
–
OFF
Lighting switch OFF
IGN
ON
Ignition switch ON
–
OFF
Ignition switch ACC or OFF
Reverse
ON
A/T selector lever “R” position
–
OFF
A/T selector lever in other “R” position
–
Ignition switch in ACC position
System part
Check item, diagnosis mode
Description
MULTI AV
VERSION
Displays unit version.
SELF-DIAG RESULTS
●
Checks for the connections AV communication line.
●
Performs the unit diagnosis.
SIGNAL MONITOR
Displays unified AV control unit. Input date in real time.
VEHICLE INFORMATION AND INTEGRATED SWITCH SYSTEM /WITHOUT
NAVIGATION SYSTEM
DI-133
C
D
E
F
G
H
I
J
L
M
A
B
DI
CONSULT-II OPERATION
Refer to
GI-36, "CONSULT-II Start Procedure"
.
VERSION
Displays version of each unit connected to the AV control unit.
SELF-DIAGNOSIS RESULTS
The self-diagnosis is started and self-diagnosis results are displayed by touching “START” after selecting
“SELF-DIAG RESULTS”.
Display Item of SELF-DIAG RESULTS
Self-diagnosis results may be displayed simultaneously according to the cause. If some error items are dis-
played simultaneously, the detection of the cause can be performed by the combination of display items.
NOTE:
When “IVCS [ABNORMAL CONNECTION]” is indicated, this is not malfunction.
Version display
Remarks
“PANEL SW”
Multifunction switch
“HEAD UNIT”
AV control unit
“REAR VIEW CAMERA”
–
“FRONT SEAT DISPLAY”
Display
“AUDIO HEAD UNIT”
–
“AIR COMP RECEIVER”
Low Tire Pressure Warning Control Unit
“BOSE AMP”
–
“IVCS”
NOTE:
Although these items are shown on the CONSULT-II screen,
impracticable. Because, these items are not applied.
“VOICE UNIT”
PKIA9680E
Error item
Possible cause
Action to take
HEAD UNIT
[ABNORMAL]
AV control unit malfunction is detected
Replace AV control unit
VOICE UNIT
[ABNORMAL]
Voice activated control module malfunction
is detected
Replace voice activated control module
●
PANEL SW
[ABNORMAL CONNECTION]
●
AUDIO HEAD UNIT
[ABNORMAL CONNECTION]
●
AIR COMP RECEIVER
[ABNORMAL CONNECTION]
●
VOICE UNIT
[ABNORMAL CONNECTION]
●
BOSE AMP
[ABNORMAL CONNECTION]
●
FRONT SEAT DISPLAY
[ABNORMAL CONNECTION]
Malfunction is detected on communication
signal
Check all communication circuits composing AV sys-
tem. Repair malfunctioning parts.
DI-134
VEHICLE INFORMATION AND INTEGRATED SWITCH SYSTEM /WITHOUT
NAVIGATION SYSTEM
●
PANEL SW
[ABNORMAL CONNECTION]
●
AUDIO HEAD UNIT
[ABNORMAL CONNECTION]
●
AIR COMP RECEIVER
[ABNORMAL CONNECTION]
●
BOSE AMP
[ABNORMAL CONNECTION]
●
FRONT SEAT DISPLAY
[ABNORMAL CONNECTION]
Malfunction is detected on communication
signal between AV control unit and display
1. Check communication circuit between AV control
unit and display.
2. If the results from the above checkup show no mal-
function, replace either AV control unit or display,
and then start self-diagnosis.
3. If self-diagnosis results still show any malfunction,
replace the other unit.
●
PANEL SW
[ABNORMAL CONNECTION]
●
AUDIO HEAD UNIT
[ABNORMAL CONNECTION]
●
AIR COMP RECEIVER
[ABNORMAL CONNECTION]
●
BOSE AMP
[ABNORMAL CONNECTION]
Malfunction is detected on communication
signal between display and multifunction
switch
1. Check communication circuit between display and
multifunction switch.
2. If the results from the above checkup show no mal-
function, replace either display or display, and then
start self-diagnosis.
3. If self-diagnosis results still show any malfunction,
replace the other unit.
PANEL SW
[ABNORMAL CONNECTION]
Multifunction switch power supply and
ground circuit malfunction is detected
1. Check multifunction switch power supply and
ground circuit.
2. If the results from the above checkup show no mal-
function, replace multifunction switch.
●
AUDIO HEAD UNIT
[ABNORMAL CONNECTION]
●
BOSE AMP
[ABNORMAL CONNECTION]
Malfunction is detected on communication
signal between multifunction switch and
audio unit
1. Check communication circuit between multifunction
switch and audio unit.
2. If the results from the above checkup show no mal-
function, replace either multifunction switch or audio
unit, and then start self-diagnosis.
3. If self-diagnosis results still show any malfunction,
replace the other unit.
AIR COMP RECEIVER
[ABNORMAL CONNECTION]
●
Low tire pressure warning control unit
power supply and ground circuit mal-
function is detected
●
Malfunction is detected on communica-
tion signal between multifunction switch
and low tire pressure warning control
unit
1. Check low tire pressure warning control unit power
supply and ground circuit.
2. Check communication circuit between multifunction
switch and low tire pressure warning control unit.
3. If the results from the above checkup show no mal-
function, replace either multifunction switch or low
tire pressure warning control unit, and then start
self-diagnosis.
4. If self-diagnosis results still show any malfunction,
replace the other unit.
BOSE AMP
[ABNORMAL CONNECTION]
●
BOSE speaker amp. power supply and
ground circuit malfunction is detected
●
Malfunction is detected on communica-
tion signal between audio unit and BOSE
speaker amp.
1. Check BOSE speaker amp. power supply and
ground circuit.
2. Check communication circuit between audio unit
and BOSE speaker amp.
3. If the results from the above checkup show no mal-
function, replace either audio unit or BOSE speaker
amp., and then start self-diagnosis.
4. If self-diagnosis results still show any malfunction,
replace the other unit.
AUDIO HEAD UNIT
[ABNORMAL CONNECTION]
Audio unit power supply and ground circuit
malfunction is detected
1. Check audio unit power supply circuit.
2. If the results from the above checkup show no mal-
function, replace audio unit.
Error item
Possible cause
Action to take
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст