Infiniti Q45. Manual — part 616
REAR DOOR GLASS AND REGULATOR
GW-57
C
D
E
F
G
H
J
K
L
M
A
B
GW
4.
Remove the harness connector routed on the frame assembly,
then remove the harness clip from the back.
5.
Operate the power window switch to raise/lower the door win-
dow until the glass mounting bolts can be seen.
6.
Remove the glass mounting bolts.
7.
Raise up the door glass and hold with a suction lifter.
8.
Remove the mounting bolts, and remove the regulator and guide
channel from the panel.
9.
Disconnect the connector for the regulator assembly.
Installation
Install in the reverse order of removal.
SIIA0289E
SIIA0290E
PIIB1881E
SIIA0291E
GW-58
REAR DOOR GLASS AND REGULATOR
Inspection after Removal
Check the regulator assembly for the following items. If a malfunc-
tion is detected, replace or grease it.
●
Wire wear
●
Regulator deformation
●
Grease condition for each sliding part
The arrows in the figure show the application points of the body
grease.
Inspection after Installation
NIS000ZB
SETTING OF LIMIT SWITCH
If any of the following work has been done, set the limit switch (integrated in the motor).
●
Removal and installation of the regulator.
●
Removal and installation of the motor from the regulator.
●
Operate the regulators a unit.
●
Removal and installation of the glass.
●
Removal and installation of the glass run.
Resetting
After installing each component to the vehicle, follow the steps
below.
CAUTION:
Do not install the frame assembly.
1.
Raise the glass to the top position.
2.
While pressing and holding the reset switch, lower the glass to
the bottom position.
3.
Release the reset switch, and check that the reset switch returns
to the original position, and then raise the glass to the top posi-
tion.
CAUTION:
Do not operate the glass automatically to raise the glass to the top position.
FITTING INSPECTION
●
Check that the glass is securely fit into the glass run groove.
●
Lower the glass slightly [approx. 10 to 20 mm (0.39 to 0.79 in)], and check that the clearance to the sash
is parallel. If the clearance between the glass and sash is not parallel, loosen the regulator mounting bolts,
the guide rail mounting bolts, and the glass and carrier plate mounting bolts to correct the glass position.
SIIA0294J
SIIA0296E
INSIDE MIRROR
GW-59
C
D
E
F
G
H
J
K
L
M
A
B
GW
INSIDE MIRROR
PFP:96321
Wiring Diagram–I/MIRR–
NIS000ZC
TIWM1562E
GW-60
INSIDE MIRROR
Removal and Installation
NIS000ZD
AUTO ANTI–DAZZLING INSIDE MIRROR
Removal
1.
Remove the connector cover.
2.
Remove TORX bolt (T20) of mirror base.
3.
Slide the mirror upward to remove, and disconnect the connector.
Installation
Install in the reverse order of removal.
1
Inside mirror
2
Connector cover
PIIA6421E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст