Infiniti Q45. Manual — part 910
CONTROL UNIT
WT-49
C
D
F
G
H
I
J
K
L
M
A
B
WT
CONTROL UNIT
PFP:40720
Removal and Installation
NES000D8
REMOVAL
1.
Turn the ignition switch OFF and disconnect the battery cable from the negative terminal.
2.
Remove the cluster lid C. Refer to
IP-10, "Removal and Installation"
3.
Remove the low tire pressure warning control unit bolt.
4.
Disconnect the low tire pressure warning control unit harness
connector and antenna harness connector.
5.
Remove the low tire pressure warning control unit (1).
INSTALLATION
Note the following, and installation is the reverse order of removal.
●
When installing the low tire pressure warning control unit, tighten bolt to the specified torque.
SEIA0753E
Low tire pressure warning control unit bolt
: 3.4 N·m (0.35 kg-m, 30 in-lb)
WT-50
COMBINATION FLASHER UNIT
COMBINATION FLASHER UNIT
PFP:25730
Removal and Installation
NES000HJ
REMOVAL
1.
Turn the ignition switch OFF and disconnect the battery cable from the negative terminal.
2.
Remove cluster lid center lower. Refer to
IP-10, "Removal and Installation"
3.
Remove console box assembly. Refer to
IP-10, "Removal and Installation"
.
4.
Remove CD auto changer. Refer to
AV-52, "Removal and Installation of CD Auto Changer"
5.
Remove combination flasher unit bolt.
6.
Remove combination flasher unit (1).
7.
Disconnect combination flasher unit harness connector.
INSTALLATION
Note the following, and installation is the reverse order of removal.
●
When installing the low tire pressure warning control unit, tighten bolt to the specified torque.
SEIA0784E
Combination flasher unit bolt
: 3.4 N·m (0.35 kg-m, 30 in-lb)
TRANSMITTER
WT-51
C
D
F
G
H
I
J
K
L
M
A
B
WT
TRANSMITTER
PFP:40700
Removal and Installation
NES000D9
REMOVAL
1.
Deflate tire. Unscrew transmitter retaining nut and allow transmitter to fall into tire.
2.
Gently bounce tire so that transmitter falls to bottom of tire.
Place on tire changing machine and break both tire beads
ensuring that the transmitter remains at the bottom of the tire.
3.
Turn tire so that valve hole is at bottom and bounce so that
transmitter is near valve hole. Carefully lift tire onto turntable and
position valve hole (and transmitter) 270 degree from mounting/
dismounting head.
4.
Lubricate tire well and remove first side of the tire. Reach inside
the tire and remove the transmitter. Remove second side of tire.
INSTALLATION
1.
Put first side of tire onto rim.
2.
Mount transmitter on rim and tighten nut.
CAUTION:
Speed for tightening nut should be less than 40 rpm.
SEIA0047E
SEIA0048E
SEIA0049E
SEIA0203E
WT-52
TRANSMITTER
3.
Place wheel on turntable of tire machine. Ensure that transmitter
is 270 degree from mounting head when second side of tire is
fitted.
CAUTION:
Never touch the transmitter at mounting head.
4.
Lubricate tire well and fit second side of tire as normal. Ensure
that tire does not rotate relative to rim.
5.
Inflate tire and fit to appropriate wheel position.
SEIA0048E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст