Infiniti G37 Coupe. Manual — part 699
EXT-10
< PRECAUTION >
PRECAUTIONS
Precaution for Procedure without Cowl Top Cover
INFOID:0000000001722830
When performing the procedure after removing cowl top cover, cover
the lower end of windshield with urethane, etc.
Precaution for Work
INFOID:0000000001677473
• After removing and installing the opening/closing parts, be sure to carry out fitting adjustments to check their
operation.
• Check the lubrication level, damage, and wear of each part. If necessary, grease or replace it.
PIIB3706J
PREPARATION
EXT-11
< PREPARATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
PREPARATION
PREPARATION
Special Service Tools
INFOID:0000000001677474
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
Commercial Service Tools
INFOID:0000000001677475
Tool number
(Kent-Moore No.)
Tool name
Description
(J-39570)
Chassis ear
Location the noise
(J-43980)
NISSAN Squeak and Rattle
Kit
Repairing the cause of noise
SIIA0993E
SIIA0994E
Tool name
Description
Engine ear
Locating the noise
Remover tool
Remove clips, pawls, metal clips
Power tool
SIIA0995E
PIIB7923J
PIIB1407E
EXT-12
< ON-VEHICLE REPAIR >
FRONT BUMPER
ON-VEHICLE REPAIR
FRONT BUMPER
Exploded View
INFOID:0000000001677476
1.
Bumper bracket RH
2.
Hood seal assembly (front)
3.
Bumper side bracket RH
4.
Bumper side stiffener RH
5.
Bumper finisher RH
6.
License plate bracket
7.
Front grille
8.
J-nut
9.
Bumper side stiffener LH
10. Bumper finisher LH
11.
Bumper bracket LH
12. Bumper reinforcement
13. Energy absorber
14.
Bumper fascia assembly (normal)
15. Grommet
JMKIA1225ZZ
FRONT BUMPER
EXT-13
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
Removal and Installation
INFOID:0000000001677477
REMOVAL
CAUTION:
Bumper fascia is made of resin. Do not apply strong force to it, and be careful to prevent contact with
oil.
1.
Fully open hood assembly.
2.
Remove clips (A) of front bumper fascia upper side.
3.
Remove radiator core support ornament. Refer to
DLK-214, "Removal and Installation"
4.
Remove clips (A) of hood seal assembly (side) LH/RH with
remover tool (B), and then remove hood seal assembly located
front portion. Refer to
DLK-217, "Removal and Installation"
.
5.
Remove bolts (A), and then remove bumper bracket (1).
16. Bumper side bracket LH
17.
Bumper finisher (center)
18. Bumper bracket cover
19. Bumper fascia assembly (sports)
: Clip
: Pawl
JMKIA1226ZZ
JMKIA1227ZZ
JMKIA1228ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст