Infiniti G37 Coupe. Manual — part 702
EXT-22
< ON-VEHICLE REPAIR >
COWL TOP
3.
Remove battery cover and brake master cylinder cover.
4.
Remove hoodledge cover mounting clips and then remove hoodledge cover (LH/RH) and cowl top cover
seal (LH/RH).
5.
Remove cowl top seal.
6.
Remove cowl top cover mounting clips.
7.
Plastic pawl (A) is pull up and cowl top cover RH (2) is removed
ahead of vehicles.
8.
Plastic pawl (B) is push down and cowl top cover LH (1) is
removed ahead of vehicles.
9.
Remove the following parts after removing cowl top cover.
• Front fender cover (LH/RH).
• EPT sealer.
INSTALLATION
Note the following, and install in the reverse order of removal.
• Install cowl top cover LH (1) with (C) (pin from front windshield
glass) aligned with concave part.
• Slide the pawl while aligning with the concave part of (E).
• Engage the joint of plastic pawl of (A) with (D), and then assemble
cowl top covers LH (1) and RH (2).
JMKIA0099GB
JMKIA0100GB
JMKIA0104GB
JMKIA0105GB
COWL TOP
EXT-23
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
CAUTION:
After installing, perform adjustment of wiper arm. Refer to
EXT-24
< ON-VEHICLE REPAIR >
FENDER PROTECTOR
FENDER PROTECTOR
FENDER PROTECTOR
FENDER PROTECTOR : Exploded View
INFOID:0000000001677484
FENDER PROTECTOR : Removal and Installation
INFOID:0000000001677485
REMOVAL
1.
Remove bolt (A) of fender protector (rear) rear end.
2.
Remove screws (B) of fender protector (rear) located center
mud guard and front fender.
3.
Remove clips of fender protector (rear).
4.
Remove fender clip from wheelhouse arches, and then remove fender protector (rear) from wheel house.
1.
Fender protector (front)
2.
Fender protector (rear)
3.
J-nut
4.
Fairing
5.
Splash guard
6.
Front fender
7.
Fender clip
8.
Grommet
JMKIA1237ZZ
JMKIA0106GB
FENDER PROTECTOR
EXT-25
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
5.
Remove bolts (A) of fender protector (front) located engine
under cover and front bumper.
6.
Remove fender protector (front) mounting clips.
7.
Remove fender clip from wheel house arches, and then remove fender protector (front) from wheel house.
8.
Remove the following parts after removing front fender protector.
• Fairing
• Fender clip
INSTALLATION
Install in the reverse order of removal.
REAR WHEEL HOUSE PROTECTOR
REAR WHEEL HOUSE PROTECTOR : Exploded View
INFOID:0000000001724881
REAR WHEEL HOUSE PROTECTOR : Removal and Installation
INFOID:0000000001724882
REMOVAL
JMKIA0107GB
1.
Rear wheel house protector
JMKIA1238ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст