Infiniti G37 Coupe. Manual — part 1039
PWO
POWER SOCKET
PWO-5
< COMPONENT DIAGNOSIS >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
JCMWA0833GB
PWO-6
< PRECAUTION >
PRECAUTIONS
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
INFOID:0000000001680380
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the “SRS AIRBAG” and “SEAT BELT” of this
Service Manual.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the “SRS AIRBAG”.
• Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har-
ness connectors.
Precaution for Battery Service
INFOID:0000000002912429
Before disconnecting the battery, lower both the driver and passenger windows. This will prevent any interfer-
ence between the window edge and the vehicle when the door is opened/closed. During normal operation, the
window slightly raises and lowers automatically to prevent any window to vehicle interference. The automatic
window function will not work with the battery disconnected.
PWO
CIGARETTE LIGHTER
PWO-7
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
ON-VEHICLE REPAIR
CIGARETTE LIGHTER
Exploded View
INFOID:0000000001680381
Removal and Installation
INFOID:0000000001680382
REMOVAL
1.
Remove console finisher. Refer to
IP-24, "Removal and Installation"
2.
Remove screws (A) from reverse side cigarette lighter socket
(1).
3.
Pull out cigarette lighter (1).
4.
Pull out the cigarette lighter socket (2) by pushing the cigarette
lighter ring pawl (C) from the cigarette lighter socket hole
(square).
INSTALLATION
Install in the reverse order of removal.
NOTE:
Align the cigarette lighter socket and the cigarette lighter ring cut out.
1
: Cigarette lighter
2
: Cigarette lighter socket
3
: Cigarette lighter ring
JPMIA0494ZZ
JPMIA0493ZZ
3
: Cigarette lighter ring
A
: Cut out
B
: Hole (square)
JPMIA0492ZZ
PWO-8
< ON-VEHICLE REPAIR >
POWER SOCKET
POWER SOCKET
Exploded View
INFOID:0000000001680383
Removal and Installation
INFOID:0000000001680384
REMOVAL
1.
Remove rear upper console assembly (A/T models) or center console assembly (M/T models). Refer to
IP-24, "Removal and Installation"
.
2.
Disconnect power socket connector (A).
3.
Pull out the inner socket (2) by pushing the ring pawl (B) from
the inner socket hole (square).
4.
Remove ring (1) from console box while pressing pawls.
INSTALLATION
Install in the reverse order of removal.
NOTE:
Align the inner socket and the ring cut out.
1
: Ring
2
: Inner socket
JPLIA0098ZZ
C
: Cut out
D
: Hole (square)
JPLIA0109ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст