Infiniti G37 Coupe. Manual — part 287
BODY CONSTRUCTION
BRM-17
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
10. Hoodledge reinforcement
11.
Upper dash
12. Lower hinge plate
13. Lower dash crossmember
14. Lower front pillar gusset
15. Front fender bracket
16. Outer sill reinforcement
17. Lower front pillar reinforcement
18. Inner sill
19. Lower dash
20. Front side member outrigger
21. Outer step sill
22. Outer sill brace
23. Inner sill reinforcement
24. Front floor
25. 2nd crossmember
26. Rear fender
27. Lock pillar reinforcement
28. Center sill reinforcement
29. 3rd crossmember
30. Upper inner lock pillar reinforcement
31. Inner lock pillar
32. Lock pillar seat belt anchor
33. Rear pillar reinforcement
34. Inner side roof rail
35. Inner rear pillar
36. Outer rear sill reinforcement
37. Outer rear wheelhouse extension
38. Outer rear wheelhouse
39. Rear side member front
40. Rear tie down hook bracket
41. Rear side member front reinforce-
ment
42. Rear floor front
43. Outer rear wheelhouse brace
44. Inner rear wheelhouse
BRM-18
< REMOVAL AND INSTALLATION >
BODY ALIGNMENT
BODY ALIGNMENT
Body Center Marks
INFOID:0000000001672394
A mark has been placed on each part of the body to indicate the vehicle center. When repairing parts dam-
aged by an accident which might affect the vehicle frame (members, pillars, etc.), more accurate and effective
repair will be possible by using these marks together with body alignment specifications.
Unit: mm (in)
: Vehicle front
Points
Portion
Marks
A, B
Upper dash
Embossment
C
Front roof
Embossment
D
Rear roof
Embossment
E
Rear waist
Embossment
F
Trans control reinforcement
Hole 14
×
12 (0.55
×
0.47)
JSKIA0372GB
BODY ALIGNMENT
BRM-19
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
Description
INFOID:0000000001672396
• All dimensions indicated in the figures are actual.
• When using a tracking gauge, adjust both pointers to equal length. Then check the pointers and gauge itself
to make sure there is no free play.
• When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
• Measurements should be taken at the center of the mounting holes.
• An asterisk (*) following the value at the measuring point indicates that the measuring point on the other side
is symmetrically the same value.
• The coordinates of the measurement points are the distances measured from the standard line of
″
X
″
,
″
Y
″
and
″
Z
″
.
•
″
Z
″
: Imaginary base line [200 mm (7.87 in) below datum line (
″
0Z
″
at design plan)]
Engine Compartment
INFOID:0000000001672397
Measurement
1.
Vehicle center
2.
Front axle center
3.
Imaginary base line
JSKIA0073GB
BRM-20
< REMOVAL AND INSTALLATION >
BODY ALIGNMENT
Figures marked with a (*) indicate symmetrically identical dimensions on both right and left hand of the vehicle.
Measurement Points
JSKIA0352GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст