Infiniti G37 Coupe. Manual — part 1072
SB-10
< ON-VEHICLE REPAIR >
REAR SEAT BELT
SEAT BELT RETRACTOR : Exploded View
INFOID:0000000001728790
SEAT BELT RETRACTOR : Removal and Installation
INFOID:0000000001728791
REMOVAL
1.
Remove the outer and inner anchors.
• Remove the rear seat cushion. Refer to
SE-160, "Removal and Installation"
.
• Remove the outer anchor fixing anchor bolt.
2.
Remove the seat belt assembly.
• Remove the rear seatback. Refer to
SE-160, "Removal and Installation"
• Remove the kicking plate inner, the rear side finisher and the rear pillar finisher. Refer to
• Remove the seat belt escutcheon from the rear pillar finisher. Refer to
INT-14, "Removal and Installa-
• Remove the retractor cover.
• Remove the fixing anchor bolt of the seat belt retractor.
INSTALLATION
Install in the reverse order of removal.
SEAT BELT BUCKLE
1.
Anchor bolt
2.
Outer anchor
3.
Seat belt buckle
4.
Retaining washer
5.
Shoulder anchor
6.
Spacer
7.
Retractor cover
8.
Seat belt retractor
Refer to
for symbols in the figure.
JMHIA0434GB
REAR SEAT BELT
SB-11
< ON-VEHICLE REPAIR >
C
D
E
F
G
I
J
K
L
M
A
B
SB
N
O
P
SEAT BELT BUCKLE : Inspection
INFOID:0000000001728792
AFTER A COLLISION
WARNING:
Inspect all seat belt assemblies including retractors and attached hardware after any collision.
NISSAN/INFINITI recommends that all seat belt assemblies in use during a collision be replaced
unless the collision was minor and the belts show no damage and continue to operate properly. Fail-
ure to do so could result in serious personal injury in an accident. Seat belt assemblies not in use dur-
ing a collision should also be replaced if either damage or improper operation is noted. Seat belt pre-
tensioners should be replaced even if the seat belts are not in use during a frontal collision in which
the air bags are deployed.
Replace any seat belt assembly (including anchor bolts) if:
• The seat belt was in use at the time of a collision (except for minor collisions and the belts, retractors and
buckles show no damage and continue to operate properly).
• The seat belt was damaged in an accident. (i.e. torn webbing, bent retractor or guide, etc.)
• The seat belt attaching point was damaged in an accident. Inspect the seat belt attaching area for damage
or distortion and repair as necessary before installing a new seat belt assembly.
• Anchor bolts are deformed or worn out.
• The seat belt pre-tensioner should be replaced even if the seat belts are not in use during the collision in
which the air bags are deployed.
PRELIMINARY CHECKS
1.
Check that the seat belt retractor, seat belt anchor and buckle bolts are securely attached.
2.
Repeat step above as necessary to check the other seat belts.
SEAT BELT BUCKLE : Exploded View
INFOID:0000000001826818
JMHIA0434GB
SB-12
< ON-VEHICLE REPAIR >
REAR SEAT BELT
SEAT BELT BUCKLE : Removal and Installation
INFOID:0000000001728794
REMOVAL
Remove the seat belt buckle.
• Remove the rear seat cushion. Refer to
SE-160, "Removal and Installation"
.
• Remove the fixing anchor bolt of the inner anchor.
INSTALLATION
Install in the reverse order of removal.
1.
Anchor bolt
2.
Outer anchor
3.
Seat belt buckle
4.
Retaining washer
5.
Shoulder anchor
6.
Spacer
7.
Retractor cover
8.
Seat belt retractor
Refer to
for symbols in the figure.
LATCH SYSTEM FOR CHILDREN
SB-13
< ON-VEHICLE REPAIR >
C
D
E
F
G
I
J
K
L
M
A
B
SB
N
O
P
LATCH SYSTEM FOR CHILDREN
Exploded View
INFOID:0000000001728795
Removal and Installation
INFOID:0000000001728796
REMOVAL
CAUTION:
Replace anchor bolts if they are deformed or worn out.
1.
Remove the rear seat cushion. Refer to
SE-160, "Removal and Installation"
.
2.
Remove LATCH (Lower Anchor and Tether for Children) system.
INSTALLATION
Install in the reverse order of removal.
1.
LATCH system
Refer to
JMHIA0435GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст