Infiniti I35 (A33). Manual — part 435
SEL553YA
GI
MA
EM
LC
EC
FE
AT
AX
SU
BR
ST
RS
BT
HA
SC
IDX
VEHICLE SECURITY (THEFT WARNING) SYSTEM
Wiring Diagram — VEHSEC — (Cont’d)
EL-341
SEF289X
CONSULT-II Inspection Procedure
=NHEL0244
“THEFT WAR ALM”
NHEL0244S01
1.
Turn ignition switch “OFF”.
2.
Connect “CONSULT-II” and “CONSULT-II CONVERTER” to
the data link connector.
SKIA3098E
3.
Turn ignition switch “ON”.
4.
Touch “START (NISSAN BASED VHCL)”.
SEL398Y
5.
Touch “SMART ENTRANCE”.
If “SMART ENTRANCE” is not indicated, go to GI-42.
SEL401Y
6.
Touch “THEFT WAR ALM”.
SEL274W
7.
Select diagnosis mode.
“DATA MONITOR”, “ACTIVE TEST” and “WORK SUPPORT”
are available.
VEHICLE SECURITY (THEFT WARNING) SYSTEM
CONSULT-II Inspection Procedure
EL-342
CONSULT-II Application Item
NHEL0245
“THEFT WAR ALM”
NHEL0245S01
Data Monitor
NHEL0245S0101
Monitored Item
Description
IGN ON SW
Indicates [ON/OFF] condition of ignition switch.
ACC ON SW
Indicates [ON/OFF] condition of ignition switch in ACC position.
KEY CYL LK SW
Indicates [ON/OFF] condition of lock signal from key cylinder switch.
KEY CYL UN SW
Indicates [ON/OFF] condition of unlock signal from key cylinder switch.
DOOR SW-RR
Indicates [ON/OFF] condition of rear door switch.
DOOR SW-DR
Indicates [ON/OFF] condition of front door switch LH.
DOOR SW-AS
Indicates [ON/OFF] condition of front door switch RH.
TRUNK SW
Indicates [ON/OFF] condition of trunk switch.
HOOD SWITCH
Indicates [ON/OFF] condition of hood switch.
LOCK SW DR/AS
Indicates [ON/OFF] condition of lock signal from door lock/unlock switch LH and RH.
UNLK SW DR/AS
Indicates [ON/OFF] condition of unlock signal from door lock/unlock LH and RH.
LK BUTTON/SIG
Indicates [ON/OFF] condition of lock signal from keyfob.
UN BUTTON/SIG
Indicates [ON/OFF] condition of unlock signal from keyfob.
TRUNK BTN/SIG
Indicates [ON/OFF] condition of trunk open signal from keyfob.
Active Test
NHEL0245S0102
Test Item
Description
THEFT IND
This test is able to check security indicator lamp operation. The lamp will be turned on when
“ON” on CONSULT-II screen is touched.
HORN
This test is able to check vehicle security alarm operation. The alarm will be activated for 0.5
seconds after “ON” on CONSULT-II screen is touched.
HEADLAMP
This test is able to check vehicle security alarm headlamp operation. The headlamp illumi-
nates for 0.5 seconds after “ON” on CONSULT-II screen is touched.
Work Support
NHEL0245S0103
Test Item
Description
THEFT ALM TRG
The switch which triggered vehicle security alarm is recorded. This mode is able to confirm
and erase the record of theft waning alarm. The trigger data can be erased by touching
“CLEAR” on CONSULT-II screen.
SECURITY ALARM SET
This mode is able to confirm and change security alarm ON-OFF setting.
GI
MA
EM
LC
EC
FE
AT
AX
SU
BR
ST
RS
BT
HA
SC
IDX
VEHICLE SECURITY (THEFT WARNING) SYSTEM
CONSULT-II Application Item
EL-343
Trouble Diagnoses
=NHEL0123
PRELIMINARY CHECK
NHEL0123S01
The system operation is canceled by turning ignition switch to
“ACC” at any step between START and ARMED in the following
flow chart.
SEL731WB
For details of “Pattern A” and “Pattern B” about vehicle security
(theft warning) system setting, refer to EL-330.
*: Refer to EL-391.
After performing preliminary check, go to symptom chart on
next page.
VEHICLE SECURITY (THEFT WARNING) SYSTEM
Trouble Diagnoses
EL-344
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст