Infiniti I35 (A33). Manual — part 402
Wiring Diagram — SROOF —
NHEL0089
MEL660R
SEL986XB
GI
MA
EM
LC
EC
FE
AT
AX
SU
BR
ST
RS
BT
HA
SC
IDX
POWER SUNROOF
Wiring Diagram — SROOF —
EL-209
SEF289X
CONSULT-II Inspection Procedure
=NHEL0223
“RETAINED PWR”
NHEL0223S01
1.
Turn ignition switch “OFF”.
2.
Connect “CONSULT-II” and “CONSULT-II CONVERTER” to
the data link connector.
SKIA3098E
3.
Turn ignition switch “ON”.
4.
Touch “START (NISSAN BASED VHCL)”.
SEL398Y
5.
Touch “SMART ENTRANCE”.
If “SMART ENTRANCE” is not indicated, go to GI-42.
SEL401Y
6.
Touch “RETAINED PWR”.
SEL274W
7.
Select diagnosis mode.
“DATA MONITOR”, “ACTIVE TEST” and “WORK SUPPORT”
are available.
POWER SUNROOF
CONSULT-II Inspection Procedure
EL-210
CONSULT-II Application Items
NHEL0224
“RETAINED PWR”
NHEL0224S01
Data Monitor
NHEL0224S0101
Monitored Item
Description
IGN ON SW
Indicates [ON/OFF] condition of ignition switch.
DOOR SW-DR
Indicates [ON/OFF] condition of front door switch LH.
DOOR SW-AS
Indicates [ON/OFF] condition of front door switch RH.
Active Test
NHEL0224S0102
Test Item
Description
RETAINED PWR
This test is able to supply RAP signal (power) from smart entrance control unit to power
window system, power sunroof system. Those systems can be operated when turning on
“RETAINED PWR” on CONSULT-II screen even if the ignition switch is tuned OFF.
NOTE:
During this test, CONSULT-II can be operated with ignition switch “OFF” position.
“RETAINED PWR” should be turned “ON” or “OFF” on CONSULT-II screen when
ignition switch is ON. Then turn ignition switch OFF for checking retained power
operation. CONSULT-II might be stuck if “RETAINED PWR” is turned “ON” or “OFF”
on CONSULT-II screen when ignition switch is OFF.
Work Support
NHEL0224S0103
Work Item
Description
RETAINED PWR SET
RAP signal’s power supply period can be changed by mode setting. Selects RAP signal’s
power supply period between two steps.
I
MODE 1 (45 sec.)/MODE 2 (OFF)/MODE 3 (2 min.)
Trouble Diagnoses
NHEL0225
Symptom
Possible cause
Repair order
Power sunroof cannot be operated
using any switch.
1. 10A fuse, 40A fusible link and
E90 circuit breaker
2. Grounds M9, M25 and M87
3. Sunroof switch
4. Sunroof switch circuit
5. Sunroof motor
1. Check 10A fuse [No. 10, located in fuse block (J/B)],
40A fusible link (letter i, located in fuse and fusible
link box) and E90 circuit breaker. Turn ignition switch
“ON” and verify battery positive voltage is present at
terminals 1 and 6 of sunroof motor.
2. Check grounds M9, M25, M87.
3. Check sunroof switch.
4. Check harness between sunroof switch and sunroof
motor.
5. Replace sunroof motor.
Power sunroof cannot be operated
using one of the sunroof switches.
1. Sunroof switch
2. Sunroof switch circuit
1. Check sunroof switch.
2. Check the harness between sunroof motor and sun-
roof switch.
GI
MA
EM
LC
EC
FE
AT
AX
SU
BR
ST
RS
BT
HA
SC
IDX
POWER SUNROOF
CONSULT-II Application Items
EL-211
Symptom
Possible cause
Repair order
Power sunroof cannot be operated
or closed fully.
1. Full closed position not initial-
ized
2. Sunroof slide mechanism
3. Sunroof switch
4. Sunroof switch circuit
5. Sunroof motor
1. Initialize full closed position.
2. Check the following.
a. Check obstacles in sunroof, etc.
b. Check worn or deformed sunroof.
c. Check sunroof sash tilted too far inward or outward.
3. Check sunroof switch.
4. Check harness between sunroof motor and sunroof
switch.
5. Replace sunroof motor.
Retained power operation does not
operate properly.
1. RAP signal circuit
2. Driver or passenger side door
switch circuit
3. Smart entrance control unit
1. Check RAP signal.
a. (With CONSULT-II)
Check RAP signal with CONSULT-II. Use “ACTIVE
TEST” mode, “RETAINED PWR” in “SMART
ENTRANCE”. (Refer to EL-210.)
If NG, go to the step b. below.
b. Verify 12 positive voltage from smart entrance control
unit is present at terminal 6 of sunroof motor:
I
Within 45 seconds after ignition switch turns off.
I
When front door LH and RH is closed.
2. Check harness between smart entrance control unit
and driver or passenger side door switch.
Check driver or passenger side door switch.
3. Check smart entrance control unit. (EL-368)
POWER SUNROOF
Trouble Diagnoses (Cont’d)
EL-212
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст