Infiniti I35 (A33). Manual — part 75
SAT010FB
22. Remove differential side bearing outer race and side bearing
adjusting shim from transmission case.
SAT031D
23. Remove differential side bearing adjusting shim from transmis-
sion case.
SAT011FB
24. Remove differential side bearing outer race from converter
housing.
SAT032D
25. Remove oil seal with screwdriver from converter housing.
I
Be careful not to damage case.
SAT063K
26. Remove differential lubricant tube from converter housing.
GI
MA
EM
LC
EC
FE
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
DISASSEMBLY
AT-297
SAT225F
27. Remove oil pump according to the following procedures.
a.
Remove O-ring from input shaft.
SAT012F
b.
Remove oil pump assembly, baffle plate and gasket from trans-
mission case.
SAT013F
c.
Remove thrust washer and bearing race from oil pump assem-
bly.
SAT014FA
28. Remove brake band according to the following procedures.
a.
Loosen lock nut, then back off anchor end pin.
I
Do not reuse anchor end pin.
SAT196F
b.
Remove brake band and strut from transmission case.
DISASSEMBLY
AT-298
SAT039D
I
To prevent brake linings from cracking or peeling, do not
stretch the flexible band unnecessarily. When removing
the brake band, always secure it with a clip as shown in
the figure at left.
Leave the clip in position after removing the brake band.
SAT040D
c.
Check brake band facing for damage, cracks, wear or burns.
SAT549F
29. Remove input shaft assembly (high clutch) and reverse clutch
according to the following procedures.
a.
Remove input shaft assembly (high clutch) with reverse clutch.
SAT566F
b.
Remove input shaft assembly (high clutch) from reverse
clutch.
SAT567F
c.
Remove needle bearings from high clutch drum and check for
damage or wear.
GI
MA
EM
LC
EC
FE
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
DISASSEMBLY
AT-299
SAT568F
d.
Remove high clutch hub and front sun gear from transmission
case.
SAT019F
e.
Remove front sun gear and needle bearing from high clutch
hub and check for damage or wear.
f.
Remove bearing race from front sun gear and check for dam-
age or wear.
SAT020F
30. Remove needle bearing from transmission case and check for
damage or wear.
SAT138F
31. Apply compressed air and check to see that low and reverse
brake operates.
SAT046D
32. Remove low one-way clutch and front planetary carrier assem-
bly according to the following procedures.
a.
Remove snap ring with flat-bladed screwdriver.
DISASSEMBLY
AT-300
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст