Infiniti I35 (A33). Manual — part 229
SEF174Y
DTC Confirmation Procedure
NHEC0900
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If DTC Confirmation Procedure has been previously conducted,
always turn ignition switch OFF and wait at least 10 seconds before
conducting the next test.
WITH CONSULT-II
NHEC0900S01
1)
Turn ignition switch ON and select “DATA MONITOR” mode
with CONSULT-II.
2)
Start engine and warm it up to the normal operating tempera-
ture.
3)
Turn ignition switch OFF and wait at least 10 seconds.
4)
Start engine and keep the engine speed between 3,500 and
4,000 rpm for at least 1 minute under no load.
5)
Let engine idle for 1 minute.
6)
If 1st trip DTC is detected, go to “Diagnostic Procedure”,
EC-260.
WITH GST
NHEC0900S02
Follow the procedure “WITH CONSULT-II” above.
GI
MA
EM
LC
FE
AT
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
DTC P0138, P0158 HO2S2
DTC Confirmation Procedure
EC-257
Wiring Diagram
=NHEC0902
BANK 1
NHEC0902S01
MEC541D
SEC661DC
DTC P0138, P0158 HO2S2
Wiring Diagram
EC-258
BANK 2
NHEC0902S02
MEC542D
SEC662DC
GI
MA
EM
LC
FE
AT
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
DTC P0138, P0158 HO2S2
Wiring Diagram (Cont’d)
EC-259
Diagnostic Procedure
NHEC0903
1
CHECK GROUND CONNECTIONS
1. Turn ignition switch OFF.
2. Loosen and retighten two engine ground screws.
Refer to “Ground Inspection”, EC-160.
SEC047D
OK or NG
OK
©
GO TO 2.
NG
©
Repair or replace ground connections.
DTC P0138, P0158 HO2S2
Diagnostic Procedure
EC-260
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст