Infiniti FX35, FX50 (S51). Manual — part 1603
SBC-70
< PRECAUTION >
PRECAUTIONS
• The seat belt was in use at the time of a collision (except for minor collisions and the belts, retractors and
buckles show no damage and continue to operate properly).
• The seat belt was damaged in an accident. (i.e. torn webbing, bent retractor or guide).
• The seat belt attaching point was damaged in an accident. Inspect the seat belt attaching area for damage
or distortion and repair as necessary before installing a new seat belt assembly.
• Anchor bolts are deformed or worn out.
• The seat belt pre-tensioner should be replaced even if the seat belts are not in use during the collision in
which the air bags are deployed.
PRE-INSPECTION FOR DIAGNOSTIC
SBC-71
< PERIODIC MAINTENANCE >
C
D
E
F
G
I
J
K
L
M
A
B
SBC
N
O
P
PERIODIC MAINTENANCE
PRE-INSPECTION FOR DIAGNOSTIC
Description
INFOID:0000000005241787
WARNING:
• The following tests should be performed in a safe, open place that is free of traffic and obstacles.
• The tests should be performed on a dry, paved road. Never attempt to perform the tests on a wet or
unpaved road, open road, or highway. (This may cause an accident or personal injury.)
• Driver and passenger should assume seat belt may operate and prepare themselves accordingly.
1.
Fasten driver and passenger seat belts.
2.
Drive at approximately 25 km/h (16 MPH).
3.
Notify passenger of a sudden stop. Driver and passenger prepare themselves for the possibility of system
not operating. Then, driver fully depresses the brake pedal to stop suddenly.
4.
Check that the shoulder of the seat belt is pulled while braking.
SBC-72
< PERIODIC MAINTENANCE >
BRAKE PEDAL STROKE SENSOR
BRAKE PEDAL STROKE SENSOR
Exploded View
INFOID:0000000005241788
Removal and Installation
INFOID:0000000005241789
REMOVAL
1.
Remove the instrument panel lower cover LH. Refer to
IP-12, "Removal and Installation"
.
2.
Disconnect the brake pedal stroke sensor connector.
3.
Remove the screws (A).
4.
Remove the brake pedal stroke sensor (1).
INSTALLATION
Install in the reverse order of removal.
1.
Brake pedal stroke sensor
JMHIA0712ZZ
JMHIA0726ZZ
PRE-CRASH SEAT BELT CONTROL UNIT
SBC-73
< PERIODIC MAINTENANCE >
C
D
E
F
G
I
J
K
L
M
A
B
SBC
N
O
P
PRE-CRASH SEAT BELT CONTROL UNIT
Exploded View
INFOID:0000000005241790
SB-6, "SEAT BELT RETRACTOR : Exploded View"
Removal and Installation
INFOID:0000000005241791
For removal and installation procedures, refer to
SB-6, "SEAT BELT RETRACTOR : Removal and Installa-
.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст