Infiniti FX35, FX50 (S51). Manual — part 1861
P0615 STARTER RELAY
TM-251
< DTC/CIRCUIT DIAGNOSIS >
[7AT: RE7R01B (VK50VE)]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Repair or replace damaged parts.
3.
CHECK HARNESS BETWEEN A/T ASSEMBLY AND IPDM E/R (PART 2)
Check the continuity between A/T assembly vehicle side harness connector terminal and ground.
Is the inspection result normal?
YES
>> GO TO 4.
NO
>> Repair or replace damaged parts.
4.
CHECK INTERMITTENT INCIDENT
GI-36, "Intermittent Incident"
.
Is the inspection result normal?
YES
>> Replace A/T assembly. Refer to
NO
>> Repair or replace damaged parts.
A/T assembly vehicle side harness connector
IPDM E/R vehicle side harness connector
Continuity
Connector
Terminal
Connector
Terminal
F51
9
E5
30
Existed
A/T assembly vehicle side harness connector
Ground
Continuity
Connector
Terminal
F51
9
Not existed
TM-252
< DTC/CIRCUIT DIAGNOSIS >
[7AT: RE7R01B (VK50VE)]
P0705 TRANSMISSION RANGE SWITCH A
P0705 TRANSMISSION RANGE SWITCH A
Description
INFOID:0000000005250227
The transmission range switch detects the selector lever position and transmits a signal to the TCM.
DTC Logic
INFOID:0000000005250228
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.
PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.
CHECK DTC DETECTION
With CONSULT-III
1.
Start the engine.
2.
Select “ACCELE POSI” and “VHCL/S SE-A/T” in “Data Monitor” in “TRANSMISSION”.
3.
Shift the selector lever throughout the entire shift position from “P” to “D”. (Hold the selector lever at each
position for 2 seconds or more)
4.
Drive vehicle and maintain the following conditions for 2 seconds or more.
5.
Perform “Self Diagnostic Results” in “TRANSMISSION”.
With GST
Follow the procedure “With CONSULT-III”.
Is “P0705” detected?
YES
>> Go to
NO
>> INSPECTION END
Diagnosis Procedure
INFOID:0000000005250229
1.
CHECK INTERMITTENT INCIDENT
GI-36, "Intermittent Incident"
Is the inspection result normal?
YES
>> Replace A/T assembly. Refer to
NO
>> Repair or replace damaged parts.
DTC
Trouble diagnosis name
DTC is detected if...
Possible cause
P0705
Transmission Range Sensor A
Circuit (PRNDL Input)
Transmission range switch sig-
nals input with impossible pat-
tern.
• Harness or connectors
(Transmission range switch-
es 1, 2, 3, 4 and TCM circuit
is open or shorted.)
• Transmission range switches
1, 2, 3 and 4
ACCELE POSI
: More than 1.0/8
VHCL/S SE-A/T
: 10 km/h (7 MPH) or more
P0710 TRANSMISSION FLUID TEMPERATURE SENSOR A
TM-253
< DTC/CIRCUIT DIAGNOSIS >
[7AT: RE7R01B (VK50VE)]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
P0710 TRANSMISSION FLUID TEMPERATURE SENSOR A
Description
INFOID:0000000005250230
The A/T fluid temperature sensor detects the A/T fluid temperature and transmits a signal to the TCM.
DTC Logic
INFOID:0000000005250231
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
CAUTION:
Always drive vehicle at a safe speed.
1.
PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.
CHECK DTC DETECTION
With CONSULT-III
1.
Start the engine.
2.
Select “SLCT LVR POSI” and “VHCL/S SE-A/T” in “Data Monitor” in “TRANSMISSION”.
3.
Drive vehicle and maintain the following conditions for 14 minutes or more.
4.
Perform “Self Diagnostic Results” in “TRANSMISSION”.
With GST
Follow the procedure “With CONSULT-III”.
Is “P0710” detected?
YES
>> Go to
NO
>> INSPECTION END
Diagnosis Procedure
INFOID:0000000005250232
1.
CHECK INTERMITTENT INCIDENT
DTC
Trouble diagnosis name
DTC is detected if...
Possible cause
P0710
Transmission Fluid Tempera-
ture Sensor A Circuit
TCM judges that the A/T fluid temperature is -40
°
C (-40
°
F) or less continuously for 5 seconds while driving at 10
km/h (7 MPH) or more.
• Harness or connectors
(Sensor circuit is open.)
• A/T fluid temperature
sensor
TCM judges that the A/T fluid temperature is 180
°
C (356
°
F) or more continuously for 5 seconds.
• Harness or connectors
(Sensor circuit is short.)
• A/T fluid temperature
sensor
TCM judges the following conditions while driving the ve-
hicle at 10 km/h (7 MPH) or more:
• The time required for A/T fluid temperature to rise by
1
°
C (1.8
°
F) exceeds 14 minutes when A/T fluid tem-
perature is -20
°
C (-4
°
F) or less.
• The time required for A/T fluid temperature to rise by
1
°
C (1.8
°
F) exceeds 7 minutes when A/T fluid tem-
perature is between -19
°
C (-2
°
F) and 0
°
C (32
°
F).
• The time required for A/T fluid temperature to rise by
1
°
C (1.8
°
F) exceeds 4 minutes when A/T fluid tem-
perature is between 1
°
C (34
°
F) and 20
°
C (68
°
F).
• Harness or connectors
(Sensor circuit is stuck.)
• A/T fluid temperature
sensor
SLCT LVR POSI
: D
VHCL/S SE-A/T
: 10 km/h (7 MPH) or more
TM-254
< DTC/CIRCUIT DIAGNOSIS >
[7AT: RE7R01B (VK50VE)]
P0710 TRANSMISSION FLUID TEMPERATURE SENSOR A
GI-36, "Intermittent Incident"
Is the inspection result normal?
YES
>> Replace A/T assembly. Refer to
NO
>> Repair or replace damaged parts.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст