Infiniti F50. Manual — part 824
TROUBLE DIAGNOSES
WT-11
C
D
F
G
H
I
J
K
L
M
A
B
WT
TEWM0019E
WT-12
TROUBLE DIAGNOSES
TEWM0004E
TROUBLE DIAGNOSES
WT-13
C
D
F
G
H
I
J
K
L
M
A
B
WT
ID Registration Procedure
EES000EO
ID REGISTRATION WITH TRANSMITTER ACTIVATION TOOL
1.
Turn ignition switch “OFF”.
2.
Connect CONSULT-II to data link connector.
3.
Touch “START”, “AIR PRESSURE MONITOR”, “WORK SUPPORT” and “ID REGIST”.
4.
With the transmitter activation tool (J-45295) pushed against the
front-left transmitter, press the button then keep 5 seconds.
5.
Register the IDs in order from FR LH, FR RH, RR RH, to RR LH. When ID registration of each wheel has
been completed, a buzzer sounds and hazard warning lamp blinks.
6.
After completing all ID registrations, press “END” to complete the procedure.
NOTE:
Be sure to register the IDs in order from FR LH, FR RH, RR RH, to RR LH, or the self-diagnostic results dis-
play will not function properly.
SEIA0101E
Activation tire position
Buzzer
Hazard warning lamp
CONSULT-II
1
FR LH
Once
2 times flashing
“YET”
↓
“DONE”
2
FR RH
2 times
3
RR RH
3 times
4
RR LH
4 times
WT-14
TROUBLE DIAGNOSES
ID REGISTRATION WITHOUT TRANSMITTER ACTIVATION TOOL
1.
Turn ignition switch “OFF”.
2.
Connect CONSULT-II to data link connector.
3.
Touch “START”, “AIR PRESSURE MONITOR”, “WORK” SUPPORT” and “ID REGIST”.
4.
Adjust the tire pressure to the values shown in the table below for ID registration, and drive the vehicle at
15 km/h (9.4 MPH) or more for a few minutes.
5.
After completing all ID registrations, press “END” to complete the procedure.
Transmitter Wake Up Operation
EES000W2
WITH TRANSMITTER ACTIVATION TOOL
1.
With the transmitter activation tool (J-45295) pushed against the
front-left transmitter, press the button then keep 5 seconds.
●
When ignition switch ON, then warning lamp is blinks as fol-
low diagram transmitter must be waken up.
2.
Register the IDs in order from FR LH, FR RH, RR RH or RR LH. When ID registration of each wheel has
been completed, a hazard warning lamp blinks.
3.
After completing wake up of all transmitters, make sure tire pressure warning lamp go out.
Tire position
Tire pressure kPa (kg/cm
2
, psi)
Front-Left
250 (2.5, 36)
Front-Right
230 (2.3, 33)
Rear-Right
210 (2.1, 30)
Rear-Left
190 (1.9, 27)
Activation tire position
CONSULT-II
FR LH
“YET”
↓
“DONE”
FR RH
RR RH
RR LH
SEIA0101E
SEIA0351E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст