Infiniti F50. Manual — part 665
STEP LAMP
LT-127
C
D
E
F
G
H
I
J
L
M
A
B
LT
6.
CHECK POWER SUPPLY CIRCUIT
1.
Turn ignition switch OFF.
2.
Disconnect step lamp connector.
3.
Check voltage between step lamp connector D10, D40, D60,
D80 terminal 1 (LG) and ground.
OK or NG
OK
>> Check harness for open or short between step lamp and
door control unit.
NG
>> Check the following.
●
10A fuse [No. 8, located in the fuse block (J/B) No. 1]
●
Harness for open or short between fuse and step lamp.
Bulb Replacement
EKS00182
1.
Remove the step lamp. Refer to
LT-127, "Removal and Installa-
2.
Insert a screwdriver in the notch and remove the lens.
3.
Remove the bulb.
Removal and Installation
EKS00183
1.
Using a clip driver or a suitable tool, press and remove the metal
clip of the step lamp.
2.
Disconnect the step lamp connector.
1 (LG) - Body ground
: Battery voltage should exist.
SKIA0475E
Step lamp
: 12V 2.7W
PKIA0075E
PKIA0076E
LT-128
DOOR MIRROR LAMP
DOOR MIRROR LAMP
PFP:96301
System Description
EKS006RU
The door mirror lamp for approx. 15 seconds when door unlocking operation is commanded with remote con-
troller.
It goes off when the driver door is opened during illumination after the door unlocking operation with remote
controller.
Power is supplied at all times
●
to door mirror lamp terminal 4
●
through 10A fuse [No. 8, located in the fuse block (J/B)NO.1]
when door unlocking operation is commanded with remote controller.
●
to BCM terminal 38
●
through BCM terminal 27 and,
●
to remote keyless entry receiver terminal 2
DOOR MIRROR LAMP
LT-129
C
D
E
F
G
H
I
J
L
M
A
B
LT
Wiring Diagram — MIRR/L —
EKS006RV
TKWM0350E
LT-130
DOOR MIRROR LAMP
Bulb Replacement
EKS006RW
DOOR MIRROR LAMP
1.
Remove the mirror from door mirror. Refer to
2.
Remove lamp socket.
3.
Remove the bulb from lamp socket.
Door mirror lamp
: 12V 8W
PKIA0084E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст