Infiniti F50. Manual — part 800
FRONT SEAT
SE-191
C
D
E
F
G
H
J
K
L
M
A
B
SE
1.
Seatback frame
2.
Seatback outer bracket
3.
Seatback inner bracket
4.
Seatback thermal electric device
5.
Seaback duct
6.
Seatback duct upper bracket
7.
Seat cushion inner bracket
8.
Seatback duct lower bracket
9.
Seat cushion frame
10. Climate controlled seat switch
11.
Climate controlled seat switch
bracket
12. Seat cushion outer bracket
13.
Seat cushion mounting upper
bracket
14. Seat cushion thermal electric device 15. Seat cushion front duct
16.
Climate controlled seat blower
motor
17. Seat cushion rear duct
18. Seat cushion duct lower bracket
19.
Seat cushion mounting lower
bracket
20. Climate controlled seat control box
21. Climate controlled seat filter
22. Seat cushion rear duct cover
SE-192
FRONT SEAT
PASSENGER SIDE POWER SEAT
SIIA0574E
FRONT SEAT
SE-193
C
D
E
F
G
H
J
K
L
M
A
B
SE
REMOVAL
When removing or installing the seat trim, carefully handle it to keep dirt out and avoid damage.
CAUTION:
●
Before removing the front seat, turn the ignition switch off, disconnect both battery cables and
wait and least 3 minutes.
●
When checking the power seat circuit for continuity using a circuit tester, do not confuse its con-
nector with the side air bag module connector. Such an error may cause the air bag to deploy.
●
Do not drop, tilt, or bump the side air bag module installing in the seat. Always handle it with care.
1.
Remove the front leg cover and rear leg cover. (LH/RH)
NOTE:
1. Slide the seat backward, and disconnect the front tabs on the front leg cover. Then move the cover
toward the rear of the vehicle, and pull up to remove.
2. Slide the seat forward, then disengage the tabs on the front LH/RH of the rear leg cover and tabs
engaged into the rail. Then pull the cover toward the rear of the vehicle.
2.
Slide the seat until the body mounting bolts are visible and a tool can be inserted.
NOTE:
When disassembling the driver seat after removal, set the front/rear cushion lifter to the top position.
3.
Disconnect both battery cables.
4.
Remove the harness connector for the side air bag module.
5.
Remove the body mounting bolts and seat belt anchor bolt.
To remove the seat belt anchor bolt, refer to
SB-3, "Removal and Installation of Front Seat Belt"
6.
Remove the power seat harness connector and vehicle harness fixing clip out of the vehicle.
NOTE:
When removing and installing, using shop clothes, protect the parts from damage where it may interfere
with others.
1.
Side air bag module
2.
Seatback frame
3.
Power seat switch (seatback)
4.
Seatback pad
5.
Seatback heater unit
6.
Headrest
7.
Seatback grip belt
8.
Seatback board
9.
Seat cushion heater unit
10. Seat cushion pad
11.
Headrest holder (free)
12. Headrest holder (locked)
13. Seatback trim
14. Seat cushion rear finisher
15. Reclining device (RH)
16. Reclining device rod
17. Reclining device (LH)
18. Seat cushion frame
19. Power seat switch (seat cushion)
20. Seat cushion trim
21. Seat cushion outer finisher
22. Reclining switch knob
23. Slide & lifter switch knob
24. Seat cushion rod (RH)
25. Lifter motor assembly
26. Seat lifter link bracket (rear)
27. Seat lifter link bracket (front)
28. Seat cushion rod (LH)
29. Inner sliding assembly
30. Seat control unit bracket
31. Flexible wire
32. Outer sliding assembly
33. Seat cushion front finisher
34. Power seat harness
35. Front leg cover (LH/RH)
36. Rear leg cover (LH/RH)
SIIA0490E
SE-194
FRONT SEAT
INSTALLATION
Install in the reverse order of removal.
NOTE:
Be sure to insert the rear end tab of the rear leg cover under the rail.
Disassembly and Assembly
EIS003R2
SEATBACK TRIM AND PAD
NOTE:
Be sure to set the front/rear cushion lifter to the top position.
1.
Remove the seatback board from the back of the seatback.
2.
Remove the retainer.
3.
From the back of the seatback, press the headrest holder tab of
the stay pipe hole to disengage. Then pull the headrest holder
up to remove.
NOTE:
Before installing the headrest holder, check its orientation (front/
rear and left/right).
4.
Remove the stay securing the inner cloth.
PIIA0163E
SIIA0113E
PIIA0164E
SIIA0579E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст