Infiniti F50. Manual — part 527
HEADLINING
EI-49
C
D
E
F
G
H
J
K
L
M
A
B
EI
HEADLINING
PFP:73910
Removal and Installation
EIS000DO
PIIA3413E
1.
Headlining (standard)
2.
Sunvisor (left)
3.
Sunvisor (right)
4.
Holder retainer
5.
Map lamp
6.
Assist grip
7
Personal lamp
8.
Headlining (sunroof)
9.
Sunroof welt
EI-50
HEADLINING
REMOVAL
1.
Remove rear seat. Refer to
SE-197, "Removal and Installation"
2.
Remove body side welt. Refer to
SE-197, "Removal and Installation"
.
3.
Remove front pillar and center pillar garnish. Refer to
SE-197, "Removal and Installation"
.
4.
Remove assist grip.
NOTE:
To remove assist grip of roof, insert small screw driver rolled
with waste into dip on mask, pull it back to your side, remove it
and remove screws (one each for left and right).
5.
Remove map lamp, disconnect connector.
6.
Remove personal lamp, disconnect connector.
7.
Remove sunvisor.
8.
Remove sunroof welt. (Only Sunroof)
9.
Disengage clips at rear of head lining, and remove trim fastener.
10. Remove holder retainer.
11. Slide front seat to the front, and set its seat back down backward.
12. Slide headlining frontward of vehicle, and disconnect hooks (if
equipped with sunroof).
10.
Map lamp & sunroof switch
11.
Over head lamp console (VIP)
12.
Over head console (STD)
13.
Assist grip (sunroof/right rear seat)
SIIA0823E
SIIA0825E
SIIA0390J
HEADLINING
EI-51
C
D
E
F
G
H
J
K
L
M
A
B
EI
13. Remove headlining, turn and remove from left rear door.
CAUTION:
●
Always remove or install in a pair.
●
Cover surroundings with waste to avoid scratches or damages.
●
Do not bend head lining too hard.
INSTALLATION
Install in the reverse order of removal.
SIIA0367J
EI-52
TRUNK ROOM TRIM & TRUNK LID FINISHER
TRUNK ROOM TRIM & TRUNK LID FINISHER
PFP:84920
Removal and Installation
EIS000DU
TRUNK ROOM TRIM
Removal
1.
Remove trunk floor carpet.
2.
Remove front spare tire cover and spare tire cover.
3.
Remove trunk floor board(left/right).
4.
Remove clips of trunk rear plate and remove trunk rear plate.
5.
Remove clips of trunk rear finisher and remove trunk rear finisher.
6.
Remove clips of trunk front finisher and remove trunk front finisher.
7.
Remove clips of trunk side finisher and remove trunk side finisher(left/right).
8.
Remove trunk hinge cover.
SIIA0887E
1.
Trunk rear plate
2.
Trunk rear finisher
3.
Trunk side finisher (left)
4.
Trunk side finisher (right)
5.
Trunk front finisher
6.
Trunk floor carpet
7.
Front spare tire cover
8.
Spare tire cover
9.
Trunk floor board (left)
10.
Tool box
11.
Trunk floor board (right)
12.
Trunk hinge cover
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст