Infiniti F50. Manual — part 697
ELECTRICAL UNITS LOCATION
PG-53
C
D
E
F
G
H
I
J
L
M
A
B
PG
CKIM0028E
PG-54
ELECTRICAL UNITS LOCATION
LUGGAGE COMPARTMENT
CKIM0192E
ELECTRICAL UNITS LOCATION
PG-55
C
D
E
F
G
H
I
J
L
M
A
B
PG
Fuse
EKS003SB
●
If fuse is blown, be sure to eliminate cause of incident before
installing new fuse.
●
Use fuse of specified rating. Never use fuse of more than speci-
fied rating.
●
Do not partially install fuse; always insert it into fuse holder prop-
erly.
●
Remove fuse for “ELECTRICAL PARTS (BAT)” if vehicle is not
used for a long period of time.
Fusible Link
EKS003SC
A melted fusible link can be detected either by visual inspection or by
feeling with finger tip. If its condition is questionable, use circuit
tester or test lamp.
CAUTION:
●
If fusible link should melt, it is possible that critical circuit
(power supply or large current carrying circuit) is shorted.
In such a case, carefully check and eliminate cause of inci-
dent.
●
Never wrap outside of fusible link with vinyl tape. Important:
Never let fusible link touch any other wiring harness, vinyl
or rubber parts.
Circuit Breaker
EKS003SD
The PTC thermistor generates heat in response to current flow. The
temperature (and resistance) of the thermistor element varies with
current flow. Excessive current flow will cause the element's temper-
ature to rise. When the temperature reaches a specified level, the
electrical resistance will rise sharply to control the circuit current.
Reduced current flow will cause the element to cool. Resistance falls
accordingly and normal circuit current flow is allowed to resume.
CEL083
CKIM0070E
SEL109W
PG-56
HARNESS CONNECTOR
HARNESS CONNECTOR
PFP:00011
Description
EKS000DY
HARNESS CONNECTOR (TAB-LOCKING TYPE)
●
The tab-locking type connectors help prevent accidental looseness or disconnection.
●
The tab-locking type connectors are disconnected by pushing or lifting the locking tab(s). Refer to the
illustration below.
Refer to the next page for description of the slide-locking type connector.
CAUTION:
Do not pull the harness or wires when disconnecting the connector.
[Example]
SEL769DA
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст