Infiniti F50. Manual — part 191
SQUEAK AND RATTLE TROUBLE DIAGNOSES
BL-11
C
D
E
F
G
H
J
K
L
M
A
B
BL
Diagnostic Worksheet
EIS000Z3
SBT860
BL-12
SQUEAK AND RATTLE TROUBLE DIAGNOSES
SBT844
HOOD
BL-13
C
D
E
F
G
H
J
K
L
M
A
B
BL
HOOD
PFP:F5100
Fitting Adjustment
EIS000GD
FRONT END HEIGHT ADJUSTMENT AND LATERAL/LONGITUDINAL CLEARANCE ADJUST-
MENT
1.
Remove the hood lock and adjust the height by rotating the bumper rubber until the hood becomes 1 to
1.5 mm (0.04 to 0.059 in) higher than the fender.
2.
Temporarily tighten the hood lock, and position it by engaging it with the hood striker. Check the lock and
striker for looseness, and tighten the lock mounting bolt to the specified torque.
CAUTION:
Adjust right/left gap between hood and each part to the following specification.
PIIA3410E
Hood and headlamp (B–B)
: Less than 1.0 mm
BL-14
HOOD
SURFACE HEIGHT ADJUSTMENT
1.
Remove the hood lock, and adjust the surface height difference of the hood and fender according to the
fitting standard dimension, by rotating RH and LH bumper rubbers.
2.
Install the hood lock temporarily, and align the food striker and lock so that the centers of striker and lock
become vertical viewed from the front, by moving the hood lock laterally.
3.
Check that the secondary latch is properly engaged with the
secondary striker with hood's own weight by dropping it from
approx. 200 mm (7.87 in) height or by pressing it lightly approx.
3 kg (29 N).
CAUTION:
Do not drop the hood from 300 mm (11.81 in) height or
higher.
4.
Move the hood lock up and down so that the striker and lock are
engaged firmly with the hood closed.
5.
Tighten the lock mounting bolts to the specified torque.
PIIA3806E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст