Infiniti F50. Manual — part 105
OVERHAUL
AT-305
D
E
F
G
H
I
J
K
L
M
A
B
AT
Oil Channel
ECS00A07
SCIA2937E
AT-306
OVERHAUL
Locations of Adjusting Shims, Needle Bearings, Thrust Washers and Snap
Rings
ECS00A08
SCIA2923E
DISASSEMBLY
AT-307
D
E
F
G
H
I
J
K
L
M
A
B
AT
DISASSEMBLY
PFP:31020
Disassembly
ECS00A09
CAUTION:
●
Do not disassemble parts behind Drum Support.
●
When replacing the control valve assembly, erase EEP ROM in TCM. Refer to
1.
Drain ATF through drain plug.
2.
Remove torque converter by holding it firmly and turing while
pulling straight out.
3.
Check torque converter one-way clutch using check tool as
shown at figure.
a.
Insert check tool into the groove of bearing support built into
one-way clutch outer race.
b.
When fixing bearing support with check tool, rotate one- way
clutch spline using screwdriver.
c.
Check that inner race rotates clockwise only. If not, replace
torque converter assembly.
4.
Remove converter housing from transmission case.
CAUTION:
Be careful not to scratch converter housing.
SCIA2297E
SCIA3171E
SCIA2298E
AT-308
DISASSEMBLY
5.
Remove O-ring from input clutch assembly.
6.
Remove tightening bolts for oil pump assembly and transmis-
sion case.
7.
Attach sliding hammer to oil pump assembly and extract it
evenly from transmission case.
CAUTION:
●
Fully tighten sliding hammer screw.
●
Make sure that bearing race is installed to the oil pump
assembly edge surface.
SCIA2299E
SCIA2300E
SCIA2301E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст