Infiniti F50. Manual — part 117
ASSEMBLY
AT-353
D
E
F
G
H
I
J
K
L
M
A
B
AT
11. Install control valve assembly.
a.
Install control valve assembly in transmission case.
CAUTION:
●
Hang down terminal cord assembly and revolution sensor harness toward outside so as not to
disturb installation of control valve assembly.
●
Make sure that turbine sensor securely installs turbine sensor hole.
●
Assemble it so that manual valve cutout is engaged with
manual plate projection.
b.
Install bolts A, B and C in control valve assembly.
c.
Tighten bolt 1, 2 and 3 temporarily to prevent dislocation. After
that tighten them in order (1
→
2
→
3), and then tighten other
bolts.
SCIA2315E
SCIA2812E
Bolt symbol
Length mm (in)
Number of bolts
A
42 (1.65)
5
B
55 (2.17)
6
C
40 (1.57)
1
SCIA2312E
: 7.9 N·m (0.81 kg-m, 70 in-lb)
SCIA3170E
AT-354
ASSEMBLY
12. Install terminal cord assembly connectors in bracket.
13. Connect terminal cord assembly connectors.
14. Connect fluid temperature sensor 2 connector.
15. Connect revolution sensor connector.
16. Securely fasten terminal harness with clip.
SCIA2584E
SCIA2309E
SCIA2581E
SCIA2313E
SCIA2314E
ASSEMBLY
AT-355
D
E
F
G
H
I
J
K
L
M
A
B
AT
17. Install oil pan in transmission case.
a.
Install oil pan gasket in transmission case.
CAUTION:
●
Do not reuse oil pan gasket.
●
Install it in the direction to align hole positions.
b.
Install oil pan in transmission case.
CAUTION:
●
Install it so that drain plug comes to the position as
shown in the figure.
●
Be careful not to pinch harnesses.
c.
Tighten oil pan mounting bolts to the specified torque in numeri-
cal order shown in the figure after temporarily tightening them.
CAUTION:
Do not reuse oil pan mounting bolts.
18. Install drain plug in oil pan.
CAUTION:
Do not reuse drain plug gasket.
19. Install torque converter.
a.
Pour ATF into torque converter.
●
Approximately 2 liter (2-1/8 US qt, 1-3/4 Imp qt) of fluid is
required for a new torque converter.
●
When reusing old torque converter, add the same amount
of fluid as was drained.
b.
Install torque converter while aligning notches of torque con-
verter with notches of oil pump.
SCIA2308E
SCIA2492E
SAT428DA
SCIA2297E
AT-356
ASSEMBLY
c.
Measure distance “A” to check that torque converter is in proper
position.
Distance “A”:
22.0 mm (0.87 in) or more
SAT017B
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст