Infiniti F50. Manual — part 114
ASSEMBLY
AT-341
D
E
F
G
H
I
J
K
L
M
A
B
AT
12. Install lip seal and D-ring in reverse brake piston.
CAUTION:
●
Do not reuse lip seal and lathe cut seal ring.
●
Apply petroleum jelly to lip seal.
●
Apply ATF to D-ring.
13. Install reverse brake piston in transmission case.
14. Install seal rings in drum support.
CAUTION:
●
Do not reuse seal rings.
●
Apply petroleum jelly to seal rings.
15. Install needle bearing in transmission case.
CAUTION:
Apply petroleum jelly to needle bearing.
SCIA2795E
SCIA2325E
SCIA3333E
SCIA2796E
AT-342
ASSEMBLY
16. After installing the return spring and spring retainer in transmis-
sion case, use a clutch spring compressor to install snap ring in
transmission case.
CAUTION:
Securely assemble them using a flat-bladed screwdriver so
that snap ring tension is slightly weak.
17. Install reverse brake retaining plate, drive plate, driven plate and
dish plate in transmission case.
18. Assemble N-spring.
19. Install snap ring in transmission case.
SCIA2436E
SCIA2322E
SCIA3179E
SCIA2439E
ASSEMBLY
AT-343
D
E
F
G
H
I
J
K
L
M
A
B
AT
20. Measure clearance between retaining plate and snap ring. If not
within specified clearance, select proper retaining plate.
21. Install return spring in parking pawl.
22. Install parking pawl and pawl shaft in output shaft & companion
flange complement.
23. Install parking actuator support in output shaft & companion
flange complement.
24. Install intermediate shaft in transmission case.
CAUTION:
Be careful not to mistake front for rear because both sides
looks similar. (Thinner end is front side.)
Specified clearance “A”:
Standard: 0.7 - 1.1mm (0.028 - 0.043 in)
Retaining plate:
Refer to
SCIA3129E
SCIA2445E
SCIA2336E
SCIA2335E
SCIA2319E
AT-344
ASSEMBLY
25. Install revolution sensor in transmission case.
26. Install needle bearing in transmission case.
CAUTION:
Apply petroleum jelly to needle bearing.
27. Apply recommended sealant (Genuine Anaerobic Liquid Gasket
GI-46, "Recommended Chemical Prod-
.) to output shaft & companion flange com-
plement as shown in illustration.
CAUTION:
Complete remove all moisture, oil and old sealant, etc.
From the transmission case and output shaft & companion
flange complement mounting surfaces.
28. Install output shaft & companion flange complement in transmis-
sion case.
29. Tighten output shaft & companion flange complement mounting
bolts to specified torque. (Because terminal bracket is tightened
together with output shaft & companion flange, it should be
installed before procedure 27.)
CAUTION:
Do not reuse self-sealing bolt.
SCIA2320E
SCIA2440E
SCIA2450E
SCIA2318E
Output shaft & companion flange complement
mounting bolt:
: 52 N·m (5.3 kg-m, 38 ft-lb)
SCIA2316E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст