Infiniti F50. Manual — part 282
VDC/TCS/ABS ACTUATOR
BRC-71
C
D
E
G
H
I
J
K
L
M
A
B
BRC
VDC/TCS/ABS ACTUATOR
PFP:47660
Removal and Installation
EFS0020P
Pay attention to the following when removing actuator.
CAUTION:
●
Before servicing, disconnect battery cables.
●
To remove brake tube, use a flare nut wrench to prevent flare nuts and brake tube from being dam-
aged. To install, use flare nut wrench (commercial service tool).
●
Do not remove and install actuator by holding harness.
●
After work is completed, bleed air from brake piping. Refer to
BR-10, "Bleeding Brake System"
.
●
Be sure to securely connect the ground cable.
SFIA0817E
BRC-72
G SENSOR
G SENSOR
PFP:47930
Removal and Installation
EFS0020Q
REMOVAL
1.
Install center console. Refer to
2.
Remove harness connector.
3.
Remove installation bolts. Remove yaw rate/side G-sensor.
CAUTION:
Do not drop or strike the yaw rate/side G-sensor, because it has
little endurance to impact.
INSTALLATION
To install, follow procedure for removal in reverse order.
CAUTION:
Do not drop or strike the yaw rate/side G-sensor, because it has little endurance to impact.
SFIA0818E
STEERING ANGLE SENSOR
BRC-73
C
D
E
G
H
I
J
K
L
M
A
B
BRC
STEERING ANGLE SENSOR
PFP:25554
Removal and Installation
EFS003XJ
REMOVAL
1.
Remove spiral cable assembly. Refer to
.
2.
Remove steering angle sensor from spiral cable assembly.
INSTALLATION
Install in the reverse order of removal.
NOTE:
After work, make sure to adjust neutral position of steering angle sensor. Refer to
Steering Angle Sensor Neutral Position"
SFIA1404E
BRC-74
STEERING ANGLE SENSOR
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст