Infiniti QX56 (Z62). Manual — part 383
DEF-42
< SYMPTOM DIAGNOSIS >
ON IS NOT DISPLAYED WHEN PRESSING REAR WINDOW DEFOGGER
SWITCH BUT IT IS OPERATED
ON IS NOT DISPLAYED WHEN PRESSING REAR WINDOW DEFOGGER
SWITCH BUT IT IS OPERATED
Diagnosis Procedure
INFOID:0000000006299466
1.
CHECK AV CONTROL UNIT FUNCTION
Check that the AV control unit is operating normally.
Refer to
AV-104, "Work Flow (Multi AV)"
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair or replace the malfunctioning parts.
2.
CONFIRM THE OPERATION
Confirm the operation again.
Is the inspection result normal?
YES
>> Check intermittent incident. Refer to
GI-40, "Intermittent Incident"
.
NO
>> GO TO 1.
FILAMENT
DEF-43
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
DEF
N
O
P
REMOVAL AND INSTALLATION
FILAMENT
Inspection and Repair
INFOID:0000000006299467
INSPECTION
1.
When measuring voltage, wrap tin foil around the top of the neg-
ative probe. Then press the foil against the wire with your finger.
2.
Attach probe circuit tester (in Volt range) to middle portion of
each filament.
3.
If a filament is burned out, circuit tester registers 0 or battery
voltage.
4.
To locate burned out point, move probe to left and right along fil-
ament. Test needle will swing abruptly when probe passes the
point.
REPAIR
REPAIR EQUIPMENT
• Conductive silver composition (Dupont No. 4817 or equivalent)
SEL122R
SEL263
SEL265
DEF-44
< REMOVAL AND INSTALLATION >
FILAMENT
• Ruler 30 cm (11.8 in) long
• Drawing pen
• Heat gun
• Alcohol
• Cloth
REPAIRING PROCEDURE
1.
Wipe broken heat wire and its surrounding area clean with a
cloth dampened in alcohol.
2.
Apply a small amount of conductive silver composition to tip of
drawing pen.
Shake silver composition container before use.
3.
Place ruler on glass along broken line. Deposit conductive silver
composition on break with drawing pen. Slightly overlap existing
heat wire on both sides [preferably 5 mm (0.20 in)] of the break.
4.
After repair has been completed, check repaired wire for conti-
nuity. This check should be conducted 10 minutes after silver
composition is deposited.
Do not touch repaired area while test is being conducted.
5.
Apply a constant stream of hot air directly to the repaired area
for approximately 20 minutes with a heat gun. A minimum dis-
tance of 3 cm (1.2 in) should be kept between repaired area and
hot air outlet.
If a heat gun is not available, let the repaired area dry for 24
hours.
PIIA0215E
SEL012D
SEL013D
DLK-1
BODY EXTERIOR, DOORS, ROOF & VEHICLE SECURITY
C
D
E
F
G
H
I
J
L
M
SECTION
DLK
A
B
DLK
N
O
P
CONTENTS
DOOR & LOCK
PRECAUTION . . . . . . . . . . . ...
PRECAUTIONS . . . . . . . . . . . . ...
Precaution Necessary for Steering Wheel Rota-
tion after Battery Disconnect . . . . . . . . .....
Precautions For Xenon Headlamp Service . . . ...
Work . . . . . . . . . . . . . . . . . . ..
PREPARATION . . . . . . . . . . ...
PREPARATION . . . . . . . . . . . . ..
Commercial Service Tools . . . . . . . . . ..
SYSTEM DESCRIPTION . . . . . . . .
COMPONENT PARTS . . . . . . . . . ...
DOOR LOCK SYSTEM . . . . . . . . . . . .
DOOR LOCK SYSTEM :
Component Parts Location . . . . . . . . .
DOOR LOCK SYSTEM : Component Description
AUTOMATIC BACK DOOR SYSTEM . . . . . ...
AUTOMATIC BACK DOOR SYSTEM :
Component Parts Location . . . . . . . . .
AUTOMATIC BACK DOOR SYSTEM :
Component Description . . . . . . . . . . ..
SYSTEM (POWER DOOR LOCK SYSTEM) . .
System Diagram . . . . . . . . . . . . . ..
System Description . . . . . . . . . . . . .
SYSTEM (INTELLIGENT KEY SYSTEM) . . ..
INTELLIGENT KEY SYSTEM . . . . . . . . ...
INTELLIGENT KEY SYSTEM : System Diagram .
INTELLIGENT KEY SYSTEM : System Descrip-
tion . . . . . . . . . . . . . . . . . . ..
DOOR LOCK FUNCTION . . . . . . . . . . ..
DOOR LOCK FUNCTION : System Diagram . . ..
DOOR LOCK FUNCTION : System Description . .
BACK DOOR OPEN FUNCTION . . . . . . . ...
BACK DOOR OPEN FUNCTION : System Dia-
gram . . . . . . . . . . . . . . . . . .
BACK DOOR OPEN FUNCTION : System De-
scription . . . . . . . . . . . . . . . . ...
REMOTE KEYLESS ENTRY FUNCTION . . . . ..
REMOTE KEYLESS ENTRY FUNCTION : Sys-
tem Diagram . . . . . . . . . . . . . . .
REMOTE KEYLESS ENTRY FUNCTION : Sys-
tem Description . . . . . . . . . . . . . .
KEY REMINDER FUNCTION . . . . . . . . .
KEY REMINDER FUNCTION : System Diagram .
KEY REMINDER FUNCTION : System Descrip-
tion . . . . . . . . . . . . . . . . . . ...
WELCOME LIGHT FUNCTION . . . . . . . . .
WELCOME LIGHT FUNCTION : System Diagram
.
WELCOME LIGHT FUNCTION : System Descrip-
tion . . . . . . . . . . . . . . . . . . ...
WARNING FUNCTION . . . . . . . . . . . ..
WARNING FUNCTION : System Description . . ..
SYSTEM (AUTOMATIC BACK DOOR SYS-
TEM) . . . . . . . . . . . . . . . . ..
System Diagram . . . . . . . . . . . . . ..
System Description . . . . . . . . . . . . ..
SYSTEM (INTEGRATED HOMELINK
TRANSMITTER) . . . . . . . . . . . .
System Description . . . . . . . . . . . . ..
DIAGNOSIS SYSTEM (BCM) . . . . . . ...
COMMON ITEM . . . . . . . . . . . . . . .
COMMON ITEM : CONSULT-III Function (BCM -
COMMON ITEM) . . . . . . . . . . . . . .
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст