Infiniti QX56 (Z62). Manual — part 814
AMBIENT SENSOR
HAC-147
< REMOVAL AND INSTALLATION >
[AUTOMATIC AIR CONDITIONING]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
AMBIENT SENSOR
Removal and Installation
INFOID:0000000006276000
REMOVAL
1.
Remove front grill. Refer to
EXT-19, "Removal and Installation"
2.
Disengage the pawl, and then remove ambient sensor from bracket.
3.
Disconnect ambient sensor connector, and then remove the ambient sensor.
INSTALLATION
Install in the reverse order of removal.
HAC-148
< REMOVAL AND INSTALLATION >
[AUTOMATIC AIR CONDITIONING]
IN-VEHICLE SENSOR
IN-VEHICLE SENSOR
FRONT A/C UNIT ASSEMBLY
FRONT A/C UNIT ASSEMBLY : Removal and Installation
INFOID:0000000006276001
REMOVAL
1.
Remove instrument lower panel LH. Refer to
IP-14, "Removal and Installation"
.
2.
Remove fixing screw, and then remove in-vehicle sensor.
INSTALLATION
Install in the reverse order of removal.
REAR A/C UNIT ASSEMBLY
REAR A/C UNIT ASSEMBLY : Removal and Installation
INFOID:0000000006276002
REMOVAL
1.
Remove rear A/C unit assembly. Refer to
HA-47, "REAR A/C UNIT ASSEMBLY : Removal and Installa-
2.
Remove the intake sensor from rear A/C unit assembly.
INSTALLATION
Note the following items, and install in the reverse order of removal.
CAUTION:
• Replace O-rings with new ones. Then apply the compressor oil to them when installing.
• Mark the mounting position of intake sensor bracket prior to removal so that the reinstalled sensor
can be located in the same position.
• Never rotate the bracket insertion part when removing and installing the intake sensor.
• Check for leakages when recharging refrigerant. Refer to
SUNLOAD SENSOR
HAC-149
< REMOVAL AND INSTALLATION >
[AUTOMATIC AIR CONDITIONING]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
SUNLOAD SENSOR
Removal and Installation
INFOID:0000000006276003
REMOVAL
1.
Remove upper ventilator grill RH. Refer to
VTL-10, "UPPER VENTILATOR GRILLE : Removal and Instal-
.
2.
Remove sunload sensor from front defroster grill RH.
3.
Disconnect harness connector from sunload sensor.
INSTALLATION
Install in the reverse order of removal.
HAC-150
< REMOVAL AND INSTALLATION >
[AUTOMATIC AIR CONDITIONING]
INTAKE SENSOR
INTAKE SENSOR
Exploded View
INFOID:0000000006276004
.
Removal and Installation
INFOID:0000000006276005
REMOVAL
1.
Remove the front evaporator assembly. Refer to
HA-43, "EVAPORATOR : Removal and Installation"
2.
Remove the intake sensor from front evaporator.
INSTALLATION
Note the following items, and install in the reverse order of removal.
CAUTION:
• Replace O-rings with new ones. Then apply the compressor oil to them when installing.
• Mark the mounting position of intake sensor bracket prior to removal so that the reinstalled sensor
can be located in the same position.
• Never rotate the bracket insertion part when removing and installing the intake sensor.
• Check for leakages when recharging refrigerant. Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст