Infiniti QX56 (Z62). Manual — part 1063
SUNROOF MOTOR ASSEMBLY
RF-35
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
RF
N
O
P
SUNROOF MOTOR ASSEMBLY
Exploded View
INFOID:0000000006141248
1.
Glass lid
2.
TORX bolt
3.
Side trim
4.
Rear drain connector
5.
Rear drain hose
6.
Sunroof bracket (LH,RH)
7.
Front drain hose
8.
Front drain connector
9.
Sunroof motor assembly
10. Sunroof unit assembly
JMKIA5212ZZ
RF-36
< REMOVAL AND INSTALLATION >
SUNROOF MOTOR ASSEMBLY
Removal and Installation
INFOID:0000000006141249
REMOVAL
CAUTION:
• Before removing sunroof motor, check that glass lid is fully closed.
• After removing sunroof motor, never attempt to rotate sunroof motor assembly as a single unit.
1.
Remove the headlining. Refer to
INT-29, "Removal and Installation"
.
2.
Disconnect connector from sunroof motor assembly.
3.
Remove sunroof motor assembly mounting screws, and then remove sunroof motor assembly.
INSTALLATION
CAUTION:
Before installing the sunroof motor assembly, be sure to the place the link and wire assembly in the
symmetrical and fully closed position.
1.
Move the sunroof motor assembly laterally by little so that the gear is completely engaged into the wire on
the sunroof unit assembly and mounting surface becomes parallel. Then secure the sunroof motor
assembly with screw.
2.
Install the headlining. Refer to
SUNROOF UNIT ASSEMBLY
RF-37
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
RF
N
O
P
SUNROOF UNIT ASSEMBLY
Exploded View
INFOID:0000000006141250
REMOVAL
DISASSEMBLY
1.
Glass lid
2.
TORX bolt
3.
Side trim
4.
Rear drain connector
5.
Rear drain hose
6.
Sunroof bracket (LH,RH)
7.
Front drain hose
8.
Front drain connector
9.
Sunroof motor assembly
10. Sunroof unit assembly
JMKIA5212ZZ
RF-38
< REMOVAL AND INSTALLATION >
SUNROOF UNIT ASSEMBLY
Removal and Installation
INFOID:0000000006141251
REMOVAL
CAUTION:
• Always work with a helper.
• Fully close the glass lid assembly, before removal, then never operate sunroof motor assembly after
removal.
• When taking sunroof unit out, use cloths to protect the seats and trim from damage.
• After installing the sunroof unit and glass lid, perform the leak test and check that there is no mal-
function.
1.
Remove the headlining. Refer to
INT-29, "Removal and Installation"
.
2.
Disconnect drain hoses.
3.
Remove the glass lid. Refer to
RF-33, "Removal and Installation"
4.
Remove the sunroof motor assembly. Refer to
RF-36, "Removal and Installation"
1.
Rear drain assembly
2.
Wind deflector
3.
Sunshade stopper
4.
Sunroof frame
5.
Sunshade
JMKIA5378ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст