Infiniti QX56 (Z62). Manual — part 1330
TRANSMISSION ASSEMBLY
TM-229
< UNIT DISASSEMBLY AND ASSEMBLY >
[7AT: RE7R01B]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
11. Remove under drive sun gear (1) from under drive carrier
assembly.
12. Remove needle bearing (1) from under drive sun gear.
13. Remove needle bearing (1) from under drive carrier assembly.
14. Remove front brake retaining plate, front brake drive plates,
front brake driven plates, and front brake dish plate from trans-
mission case by using a wire (A) with its tip bent like a hook.
15. Remove snap ring (1) from transmission case using a flat-
bladed screwdriver.
CAUTION:
• Be careful not to scratch transmission case and 1st one-
way clutch.
• Be careful not to damage snap ring.
JPDIA1112ZZ
JPDIA1113ZZ
JPDIA1114ZZ
JPDIA1115ZZ
JPDIA1116ZZ
TM-230
< UNIT DISASSEMBLY AND ASSEMBLY >
[7AT: RE7R01B]
TRANSMISSION ASSEMBLY
16. Remove input clutch assembly (with 1st one-way clutch, under
drive carrier assembly, front brake hub, front carrier assembly,
and rear internal gear) (1) from transmission case.
17. Remove 1st one-way clutch (1) from front brake hub.
18. Remove under drive carrier assembly (with front brake hub) (1)
from front carrier assembly.
19. Remove needle bearing (1) from front carrier assembly.
20. Remove seal rings (1) from input clutch assembly.
JPDIA1117ZZ
JPDIA1118ZZ
JPDIA1119ZZ
JPDIA1120ZZ
JPDIA1121ZZ
TRANSMISSION ASSEMBLY
TM-231
< UNIT DISASSEMBLY AND ASSEMBLY >
[7AT: RE7R01B]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
21. Remove mid carrier assembly and rear carrier assembly as a
unit.
22. Remove mid carrier assembly from rear carrier assembly.
23. Remove needle bearing (front side) from mid carrier assembly.
24. Remove needle bearing (rear side) from mid carrier assembly.
25. Remove bearing race from rear carrier assembly.
SCIA5017E
SCIA5697E
SCIA2805E
SCIA2804E
SCIA5175E
TM-232
< UNIT DISASSEMBLY AND ASSEMBLY >
[7AT: RE7R01B]
TRANSMISSION ASSEMBLY
26. Remove needle bearing from rear carrier assembly.
27. Remove mid sun gear assembly, rear sun gear assembly, and
high and low reverse clutch hub as a unit.
CAUTION:
Be careful to remove then with bearing race and needle
bearing.
28. Remove high and low reverse clutch assembly from direct clutch
assembly.
CAUTION:
Make sure that needle bearing is installed to the high and
low reverse clutch assembly edge surface.
29. Remove direct clutch assembly from reverse brake.
30. Remove needle bearing from drum support.
SCIA2803E
SCIA5018E
SCIA2306E
SCIA5019E
SCIA5198E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст