Infiniti QX56 (Z62). Manual — part 1336
TRANSMISSION ASSEMBLY
TM-253
< UNIT DISASSEMBLY AND ASSEMBLY >
[7AT: RE7R01B]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
28. Install direct clutch assembly in reverse brake.
CAUTION:
Make sure that drum support edge surface and direct clutch
inner boss edge surface come to almost same place.
29. Install high and low reverse clutch assembly in direct clutch.
30. Align the drive plate using a flat-bladed screwdriver.
31. Install high and low reverse clutch hub, mid sun gear assembly,
and rear sun gear assembly as a unit.
CAUTION:
SCIA5019E
SCIA2306E
SCIA3169E
SCIA5018E
TM-254
< UNIT DISASSEMBLY AND ASSEMBLY >
[7AT: RE7R01B]
TRANSMISSION ASSEMBLY
Make sure that portion “A” of high and low reverse clutch
drum protrudes approximately 2 mm (0.08 in) beyond por-
tion “B” of rear sun gear.
32. Install needle bearing in rear carrier assembly.
CAUTION:
Check the direction of needle bearing. Refer to
"Location of Needle Bearings and Bearing Races"
33. Install bearing race in rear carrier assembly.
CAUTION:
Check the direction of needle bearing. Refer to
"Location of Needle Bearings and Bearing Races"
34. Install rear carrier assembly in direct clutch drum.
35. Install needle bearing (rear side) to mid carrier assembly.
CAUTION:
Check the direction of needle bearing. Refer to
"Location of Needle Bearings and Bearing Races"
SCIA3130E
SCIA2803E
SCIA5175E
SCIA2462E
SCIA2804E
TRANSMISSION ASSEMBLY
TM-255
< UNIT DISASSEMBLY AND ASSEMBLY >
[7AT: RE7R01B]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
36. Install needle bearing (front side) to mid carrier assembly.
CAUTION:
Check the direction of needle bearing. Refer to
"Location of Needle Bearings and Bearing Races"
37. Install mid carrier assembly in rear carrier assembly.
38. Install seal rings (1) to input clutch assembly.
39. Install needle bearing (1) to front carrier assembly.
CAUTION:
Check the direction of needle bearing. Refer to
"Location of Needle Bearings and Bearing Races"
SCIA2805E
SCIA5017E
JPDIA1121ZZ
JPDIA1120ZZ
TM-256
< UNIT DISASSEMBLY AND ASSEMBLY >
[7AT: RE7R01B]
TRANSMISSION ASSEMBLY
40. Install input clutch assembly (with front carrier assembly and
rear internal gear) (1) to transmission case.
CAUTION:
Check that the needle bearing (2) is securely positioned. If
the needle bearing position is misaligned, adjust it to the
specified position.
41. Install 1st one-way clutch (1) to front brake hub (with under drive
carrier) (2).
42. Check operation of 1st one-way clutch.
a.
Hold 1st one-way clutch.
b.
Check front brake hub for correct locking and unlocking direc-
tions.
CAUTION:
If not shown in figure, check installation direction of 1st one-way clutch.
43. Install under drive carrier (with 1st one-way clutch) (1) to trans-
mission case.
JSDIA1714ZZ
: Unlocked
: Locked
JSDIA1713ZZ
JSDIA1715ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст