Infiniti QX56 (Z62). Manual — part 312
DAS
OPERATION
DAS-285
< SYSTEM DESCRIPTION >
[LDW & LDP]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
OPERATION
LANE DEPARTURE WARNING (LDW) SYSTEM
LANE DEPARTURE WARNING (LDW) SYSTEM : Switch Name and Function
INFOID:0000000006223710
LANE DEPARTURE WARNING (LDW) SYSTEM : Menu Displayed by Pressing Each
Switch
INFOID:0000000006223711
INDICATOR LAMP AND WARNING LAMP
DISPLAY AND WARNING
JSOIA0277ZZ
No.
Switch name
Description
1
Warning systems switch
Turns LDW/FCW/BSW systems ON/OFF
JSOIA0345ZZ
No.
Display item
Description
1
Warning systems ON indicator
• Indicates that the LDW/FCW/BSW systems are ON
• Blinks when the initial setting of LDW/FCW/BSW system is changed
2
Lane departure warning lamp
• Blinks when LDW system is activated
• Turns ON when LDW system has a malfunction
• Blinks when the temperature of the lane camera unit becomes high
DAS-286
< SYSTEM DESCRIPTION >
[LDW & LDP]
OPERATION
NOTE:
After the operating conditions of warning are satisfied, the warning continues until the vehicle speed reaches
approximately 60 km/h (40 MPH). Refer to
DAS-277, "LANE DEPARTURE WARNING (LDW) SYSTEM : Sys-
LANE DEPARTURE PREVENTION (LDP) SYSTEM
LANE DEPARTURE PREVENTION (LDP) SYSTEM : Switch Name and Function
INFOID:0000000006223712
LANE DEPARTURE PREVENTION (LDP) SYSTEM : Menu Displayed by Pressing
Each Switch
INFOID:0000000006223713
INDICATOR LAMP AND WARNING LAMP
Vehicle condition/ Driver's operation
Action
Driver warning
systems ON in-
dicator
Indication on the combination
meter
Buzzer
Less than Ap-
prox. 60 km/h
(40 MPH)
Close to lane marker
No action
ON
OFF
—
Approx. 70
km/h (45
MPH) or more
Close to lane marker
Warning
• Buzzer sounds
• Warning lamp
blinks
ON
Short con-
tinuous
beeps
• Close to lane marker
• Turn signal ON (Deviate
side)
No action
ON
OFF
—
JPOIA0018GB
JSOIA0369ZZ
No.
Switch name
Description
1
Dynamic driver assistance switch
Turns LDP system ON/OFF
(When the setting of LDP system on the navigation system setting screen is ON)
2
LDP system settings screen
(Navigation system settings screen)
The setting of LDP system can be switched between ON and OFF
JSOIA0243ZZ
DAS
OPERATION
DAS-287
< SYSTEM DESCRIPTION >
[LDW & LDP]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
DISPLAY AND WARNING
NOTE:
After the operating conditions are satisfied, the control continues until the vehicle speed reaches approxi-
mately 60 km/h (40 MPH). Refer to
DAS-280, "LANE DEPARTURE PREVENTION (LDP) SYSTEM : System
.
No.
Display item
Description
1
LDP ON indicator (green)
• Indicates that LDP system is ON
• Blinks when dynamic driver assistance switch is pressed
(When the setting of LDP system and DCA system are “OFF”)
Lane departure warning lamp (yel-
low)
• Blinks when the warning of LDP system occurs
• Turns ON when LDP system has a malfunction
• Blinks when the temperature of lane camera unit becomes high
Vehicle condition/ Driver's operation
Action
Indication on the combination meter
Buzzer
Less than Ap-
prox. 60 km/h
(40 MPH)
Close to lane marker
No action
—
Approx. 70
km/h (45
MPH) or more
Close to lane marker
Warning and yawing
• Buzzer sounds
• Warning lamp blinks
• Brake control
Short continu-
ous beeps
• Close to lane marker
• Turn signal ON (Deviate
side)
No action
—
Close to lane with soft brak-
ing
Warning
• Buzzer sounds
• Warning lamp blinks
Short continu-
ous beeps
• VDC OFF Switch
OFF
⇒
ON
(VDC system ON
⇒
OFF)
• SNOW mode switch
OFF
⇒
ON
• 4WD shift switch is in the
4H or 4L
Cancellation
• Buzzer sounds
• Indicator lamp blinks
NOTE:
When dynamic driver assis-
tance switch is ON
⇒
OFF, in-
dicator lamp is turned OFF
Beep
JPOIA0021GB
JPOIA0022GB
JPOIA0021GB
JPOIA0022GB
JPOIA0023GB
DAS-288
< SYSTEM DESCRIPTION >
[LDW & LDP]
HANDLING PRECAUTION
HANDLING PRECAUTION
Precautions for Lane Departure Warning/Lane Departure Prevention
INFOID:0000000006223714
LANE CAMERA UNIT HANDLING
To keep the proper operation of the LDW/LDP systems and prevent a system malfunction, be sure to observe
the following:
• Always keep the windshield clean.
• Do not attach a sticker (including transparent material) or install an accessory near the lane camera unit.
• Do not place reflective materials, such as white paper or a mirror, on the instrument panel. The reflection of
sunlight may adversely affect the lane camera unit capability of detecting the lane markers.
• Do not strike or damage the areas around the lane camera unit.
• Do not touch the camera lens.
• Do not remove the screw located on the lane camera unit.
LANE DEPARTURE WARNING (LDW)
• LDW system is only a warning device to inform the driver of a potential unintended lane departure. It will not
steer the vehicle or prevent loss of control. It is the driver’s responsibility to stay alert, drive safely, keep the
vehicle in the traveling lane, and be in control of the vehicle at all times.
• LDW system will not operate at speeds below approximately 70 km/h (45 MPH) or if it cannot detect lane
markers.
• Excessive noise will interfere with the warning chime sound, and the chime may not be heard.
• LDW system may not function properly under the following conditions:
- On roads where there are multiple parallel lane markers; lane markers that are faded or not painted clearly;
yellow painted lane markers; non-standard lane markers; or lane markers covered with water, dirt or snow,
etc.
- On roads where the discontinued lane markers are still detectable.
- On roads where there are sharp curves.
- On roads where there are sharply contrasting objects, such as shadows, snow, water, wheel ruts, seams or
lines remaining after road repairs. (The LDW system could detect these items as lane markers.)
- On roads where the traveling lane merges or separates.
- When the vehicle's traveling direction does not align with the lane marker.
- When traveling close to other vehicle in front of the vehicle, which obstructs the lane camera unit detection
range.
- When rain, snow or dirt adheres to the windshield in front of the lane camera unit.
- When the headlights are not bright due to dirt on the lens or if the aiming is not adjusted properly.
- When strong light enters the lane camera unit. (For example, the light directly shines on the front of the vehi-
cle at sunrise or sunset.)
- When a sudden change in brightness occurs. (For example, when the vehicle enters or exits a tunnel or
under a bridge.)
LANE DEPARTURE PREVENTION (LDP)
• LDP system will not steer the vehicle or prevent loss of control. It is the driver’s responsibility to stay alert,
drive safely, keep the vehicle in the traveling lane, and be in control of vehicle at all times.
• LDP system is primarily intended for use on well-developed freeways or highways. It may not detect the lane
markers in certain roads, weather or driving conditions.
• Using the LDP system under some conditions of road, lane marker or weather, or when driver change lanes
without using the turn signal could lead to an unexpected system operation. In such conditions, driver needs
to correct the vehicle's direction with driver's steering operation to avoid accidents.
• When the LDP system is operating, avoid excessive or sudden steering maneuvers. Otherwise, driver could
lose control of the vehicle.
• The LDP system will not operate at speeds below approximately 70 km/h (45 MPH) or if it cannot detect lane
markers.
• The LDP system may not function properly under the following conditions, and do not use the LDP system:
- During bad weather (rain, fog, snow, wind, etc.).
- When driving on slippery roads, such as on ice or snow, etc.
- When driving off-road such as on sand or rock, etc.
- When driving on winding or uneven roads.
- When there is a lane closure due to road repairs.
- When driving in a makeshift lane.
- When driving on roads where the lane width is too narrow.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст