Infiniti G35 (V35) Sedan. Manual — part 1101
PWC-236
< PRECAUTION >
[FRONT WINDOW ANTI-PINCH]
PRECAUTIONS
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
INFOID:0000000000961738
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SRS and SB section of this Service Man-
ual.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the SRS section.
• Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har-
ness connectors.
PRE-INSPECTION FOR DIAGNOSTIC
PWC-237
< ON-VEHICLE MAINTENANCE >
[FRONT WINDOW ANTI-PINCH]
C
D
E
F
G
H
I
J
L
M
A
B
PWC
N
O
P
ON-VEHICLE MAINTENANCE
PRE-INSPECTION FOR DIAGNOSTIC
Basic Inspection
INFOID:0000000000961739
BASIC INSPECTION
1.
INSPECTION START
1.
Check the service history.
2.
Check the following parts.
• Fuse/circuit breaker blown.
• Poor connection, open or short circuit of harness connector.
• Battery voltage.
Is the inspection result normal?
YES
>> Inspection end.
NO
>> Repair or replace the malfunctioning parts.
PWC-238
< ON-VEHICLE REPAIR >
[FRONT WINDOW ANTI-PINCH]
POWER WINDOW MAIN SWITCH
ON-VEHICLE REPAIR
POWER WINDOW MAIN SWITCH
Removal and Installation
INFOID:0000000000961740
REMOVAL
1.
Remove the power window main switch finisher (2).
Refer to
INT-10, "Removal and Installation"
2.
Power window main switch (1) is removed from power window
main switch finisher (2) using flat-head screw driver (A) etc.
CAUTION:
Do not fold the pawl of power window main switch finisher.
NOTE:
The same procedure is also performed for front power window
switch (passenger side) and rear power window switch (LH & RH).
INSTALLATION
Install in the reverse order of removal.
: Pawl
JMKIA0150ZZ
PWO
PWO-1
ELECTRICAL & POWER CONTROL
C
D
E
F
G
H
I
J
K
L
B
SECTION
PWO
A
O
P
N
CONTENTS
POWER OUTLET
COMPONENT DIAGNOSIS . . . . . . ..
CIGARETTE LIGHTER . . . . . . . . . ...
Wiring Diagram — Cigarette Lighter — . . . . .....
POWER SOCKET . . . . . . . . . . . ...
Wiring Diagram — Power Socket — . . . . . .....
PRECAUTION . . . . . . . . . . . ...
PRECAUTIONS . . . . . . . . . . . . ...
ON-VEHICLE REPAIR . . . . . . . . ..
CIGARETTE LIGHTER . . . . . . . . . ..
Exploded View . . . . . . . . . . . . . . ..
Removal and Installation . . . . . . . . . . ..
POWER SOCKET . . . . . . . . . . . ..
Exploded View . . . . . . . . . . . . . . ..
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст