Infiniti G35 (V35) Sedan. Manual — part 842
LAN
CAN COMMUNICATION SYSTEM
LAN-37
< COMPONENT DIAGNOSIS >
[CAN]
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
JCMWA0015GB
LAN-38
< COMPONENT DIAGNOSIS >
[CAN]
CAN COMMUNICATION SYSTEM
JCMWA0016GB
LAN
MALFUNCTION AREA CHART
LAN-39
< COMPONENT DIAGNOSIS >
[CAN]
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
MALFUNCTION AREA CHART
Main Line
INFOID:0000000000963946
Branch Line
INFOID:0000000000963947
Short Circuit
INFOID:0000000000963948
Malfunction Area
Reference
Main line between BCM and data link connector
Main line between data link connector and ABS actuator and
electric unit (control unit)
Main line between data link connector and driver seat control unit
Main line between driver seat control unit and ABS actuator and
electric unit (control unit)
Malfunction Area
Reference
ECM branch line circuit
AWD control unit branch line circuit
Air bag diagnosis sensor unit branch line circuit
AV control unit branch line circuit
BCM branch line circuit
TCM branch line circuit
AFS control unit branch line circuit
Data link connector branch line circuit
Unified meter and A/C amp. branch line circuit
Steering angle sensor branch line circuit
4WAS main control unit branch line circuit
Driver seat control unit branch line circuit
ABS actuator and electric unit (control unit) branch line circuit
ICC sensor integrated unit branch line circuit
IPDM E/R branch line circuit
Malfunction Area
Reference
CAN communication circuit
LAN-40
< COMPONENT DIAGNOSIS >
[CAN]
MAIN LINE BETWEEN BCM AND DLC CIRCUIT
MAIN LINE BETWEEN BCM AND DLC CIRCUIT
Diagnosis Procedure
INFOID:0000000000963949
INSPECTION PROCEDURE
1.
CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
1.
Turn the ignition switch OFF.
2.
Disconnect the battery cable from the negative terminal.
3.
Disconnect the following harness connectors.
-
ECM harness connector
-
BCM harness connector
4.
Check the continuity between the BCM harness connector and the data link connector.
Is the inspection result normal?
YES (Present error)>>Check CAN system type decision again.
YES (Past error)>>Error was detected in the main line between the BCM and the data link connector.
NO
>> Repair the main line between the BCM and the data link connector.
BCM harness connector
Data link connector
Continuity
Connector No.
Terminal No.
Connector No.
Terminal No.
M122
91
M24
6
Existed
90
14
Existed
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст