Infiniti G35 (V35) Sedan. Manual — part 1240
SRC-108
< COMPONENT DIAGNOSIS >
B1106, B1107, B1108, B1109, B1110, B1111 DIAGNOSIS SENSOR UNIT
With CONSULT-lll
CAUTION:
• Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least 3 min-
utes. (To discharge backup capacitor.)
• Do not use unspecified tester or other measuring device.
DIAGNOSTIC PROCEDURE
1.
CHECK HARNESS CONNECTOR
Check the harness connector.
Are connections of harness connectors and terminals correct?
YES
>> GO TO 2.
NO
>> Repair or replace harness connectors.
2.
CHECK WIRING HARNESS
Check the wiring harness.
Is the outside of wiring harness normal, without any damage?
YES
>> GO TO 3.
NO
>> Replace wiring harness.
3.
CHECK DIAGNOSIS SENSOR UNIT
Check the displayed on CONSULT-lll?
Is “DIAGNOSIS SENSOR UNIT” displayed on CONSULT-lll?
YES
>> Replace diagnosis sensor unit (ACU).
>> INSPECTION END.
B1113, B1114 SATELLITE SENS RH
SRC-109
< COMPONENT DIAGNOSIS >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
B1113, B1114 SATELLITE SENS RH
Description
INFOID:0000000000959687
DTC B1113, B1114 [UNIT FAIL] SATELLITE SENS RH
Main “G” sensor generates signal voltage when it detects deceleration beyond the specified level by vehicle
side collision.
OPERATION
When ACU define the both signal voltage of the “G” sensor and the Safing sensor to be that of collision which
exceeds specified level, the driving circuit switches on and feed the electric ignitor of both the side air bag and
curtain air bag.
STRUCTURE
Integrated type of the G sensor element for side collision with output terminals for signal voltage.
INSTALLATION
Satellite sensor is installed at the underside of center pillar with fixed nuts.
DTC Logic
INFOID:0000000000959688
DTC DETECTION LOGIC
With CONSULT-lll
DTC No. Index (“SELF-DIAG [CURRENT]”), (“SELF-DIAG [PAST]” or “TROUBLE DIAG RECORD”)
Without CONSULT-lll
Warning Lamp Flash Code Chart
DTC CONFIRMATION PROCEDURE (With CONSULT-lll)
1.
IGNITION SWITCH
Turn ignition switch ON.
>> GO TO 2.
2.
CONSULT-LLL
Select “DIAG MODE” with CONSULT-lll.
DTC No.
Trouble diagnosis name
DTC detecting condition
Possible cause
B1113
B1114
SATELLITE SENS RH
[UNIT FAIL]
RH satellite sensor is out of order.
1.
Visually check the wiring harness-
connection.
2.
Replace the harness if it has visi-
ble damage.
3.
Replace RH satellite sensor.
4.
Replace diagnosis sensor unit
(ACU).
JMHIA0039GB
SRC-110
< COMPONENT DIAGNOSIS >
B1113, B1114 SATELLITE SENS RH
>>
3.
DTC CODE
If DTC is detected. Refer to
>> END
DTC CONFIRMATION PROCEDURE (Without CONSULT-lll)
NOTE:
• SRS will not enter diagnosis mode if no malfunction is detected in user mode.
1.
IGNITION SWITCH
Turn ignition switch ON.
>> GO TO 2.
2.
USER MODE-DIAG MODE
After air bag warning lamp illuminates for 7 seconds, turn ignition switch OFF within 1 second.
>> GO TO 3.
3.
USER MODE-DIAG MODE
Wait more than 3 seconds.
>> GO TO 4.
4.
USER MODE-DIAG MODE
Repeat step 1 to 3 twice. (Perform three times in all.)
>> GO TO 5.
5.
DIAG MODE
Turn ignition switch ON. (SRS is now in diagnosis mode.)
>> GO TO 6.
6.
DIAG MODE (AIR BAG WARNING LAMP)
Malfunctioning portion is indicated according to blinking times of air bag warning lamp. Refer to
>> END
Diagnosis Procedure (Component diagnosis)
INFOID:0000000000959689
B1113, B1114 SATELLITE SENS RH
SRC-111
< COMPONENT DIAGNOSIS >
C
D
E
F
G
I
J
K
L
M
A
B
SRC
N
O
P
With CONSULT-lll
CAUTION:
• Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least 3 min-
utes. (To discharge backup capacitor.)
• Do not use unspecified tester or other measuring device.
DIAGNOSTIC PROCEDURE
1.
CHECK HARNESS CONNECTOR
Check the harness connector.
Are connections of harness connectors and terminals correct?
YES
>> GO TO 2.
NO
>> Repair or replace harness connectors.
2.
CHECK WIRING HARNESS
Check the wiring harness.
Is the outside of wiring harness normal, without any damage?
YES
>> GO TO 3.
NO
>> Replace wiring harness.
3.
CHECK SATELLITE SENSOR
Check the displayed on CONSULT-lll.
Is “SATELLITE SENSOR” displayed on CONSULT-lll?
YES
>> Replace satellite sensor.
NO
>> Replace diagnosis sensor unit (ACU).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст