Infiniti G35 (V35) Sedan. Manual — part 1366
TM-156
< COMPONENT DIAGNOSIS >
[5AT: RE5R05A]
P1757 FRONT BRAKE SOLENOID VALVE
NO
>> Repair or replace damaged parts.
P1762 DIRECT CLUTCH SOLENOID VALVE
TM-157
< COMPONENT DIAGNOSIS >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
P1762 DIRECT CLUTCH SOLENOID VALVE
Description
INFOID:0000000000957080
• The direct clutch solenoid valve is controlled by the TCM in response to signals sent from the PNP switch,
vehicle speed sensor and accelerator pedal position sensor (throttle position sensor). Gears will then be
shifted to the optimum position.
• The direct clutch solenoid valve controls the direct clutch control valve in response to a signal sent from the
TCM.
DTC Logic
INFOID:0000000000957081
DTC DETECTION LOGIC
*: This is an OBD-II self-diagnostic item.
DTC CONFIRMATION PROCEDURE
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch
OFF and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
1.
CHECK DTC DETECTION
With CONSUTL-III
1.
Start the engine.
2.
Select “DATA MONITOR”.
3.
Drive vehicle and maintain the following conditions for at least 5 consecutive seconds.
With GST
Follow the procedure “With CONSULT-III”.
Is “P1762 D/C SOLENOID/CIRC” detected?
YES
>> Go to
NO
>> Check Intermittent incident. Refer to
GI-39, "Intermittent Incident"
.
Diagnosis Procedure
INFOID:0000000000957082
1.
CHECK TCM POWER SUPPLY AND GROUND CIRCUIT
Check TCM power supply and ground circuit. Refer to
Is the inspection result normal?
YES
>> Replace the control valve with TCM. Refer to
DTC
Item
(CONSULT-III screen
terms)
A/T CHECK indicator
lamp judgment flicker
Diagnostic item is de-
tected when...
Possible cause
P1762*
D/C SOLENOID/CIRC
2nd
• Normal voltage not ap-
plied to solenoid due
to cut line, short, or the
like.
• TCM detects as irregu-
lar by comparing tar-
get value with monitor
value.
• Harness or connectors
(Solenoid circuit is
open or shorted.)
• Direct clutch solenoid
valve
ACCELE POSI
: 1.5/8 – 2.0/8
GEAR
: “1”
⇒
“2” (D/C ON/OFF)
SLCT LVR POSI
: “D” position
Driving location
: Driving the vehicle uphill (increased engine load) will help maintain the driving con-
ditions required for this test.
TM-158
< COMPONENT DIAGNOSIS >
[5AT: RE5R05A]
P1762 DIRECT CLUTCH SOLENOID VALVE
NO
>> Repair or replace damaged parts.
P1767 HIGH AND LOW REVERSE CLUTCH SORENOID VALVE
TM-159
< COMPONENT DIAGNOSIS >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
P1767 HIGH AND LOW REVERSE CLUTCH SORENOID VALVE
Description
INFOID:0000000000957083
• The high and low reverse clutch solenoid valve is controlled by the TCM in response to signals sent from the
PNP switch, vehicle speed sensor and accelerator pedal position sensor (throttle position sensor). Gears will
then be shifted to the optimum position.
• The high and low reverse clutch solenoid valve controls the high and low reverse clutch control valve in
response to a signal sent from the TCM.
DTC Logic
INFOID:0000000000957084
DTC DETECTION LOGIC
*: This is an OBD-II self-diagnostic item.
DTC CONFIRMATION PROCEDURE
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch
OFF and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
1.
CHECK DTC DETECTION
With CONSULT-III
1.
Start the engine.
2.
Select “DATA MONITOR”.
3.
Drive vehicle and maintain the following conditions for at least 5 consecutive seconds.
With GST
Follow the procedure “With CONSULT-III”.
Is “P1767 HLR/C SOL/CIRC” detected?
YES
>> Go to
NO
>> Check Intermittent incident. Refer to
GI-39, "Intermittent Incident"
.
Diagnosis Procedure
INFOID:0000000000957085
1.
CHECK TCM POWER SUPPLY AND GROUND CIRCUIT
Check TCM power supply and ground circuit. Refer to
Is the inspection result normal?
YES
>> Replace the control valve with TCM. Refer to
DTC
Item
(CONSULT-III screen
terms)
A/T CHECK indicator
lamp judgment flicker
Diagnostic item is de-
tected when...
Possible cause
P1767*
HLR/C SOL/CIRC
8th
• Normal voltage not ap-
plied to solenoid due
to cut line, short, or the
like.
• TCM detects as irregu-
lar by comparing tar-
get value with monitor
value.
• Harness or connectors
(Solenoid circuit is
open or shorted.)
• High and low reverse
clutch solenoid valve
ACCELE POSI
: 1.5/8 – 2.0/8
GEAR
: “2”
⇒
“3” (HLR/C ON/OFF)
SLCT LVR POSI
: “D” position
Driving location
: Driving the vehicle uphill (increased engine load) will help maintain the driving
conditions required for this test.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст