Infiniti G35 (V35) Sedan. Manual — part 1370
TM-172
< COMPONENT DIAGNOSIS >
[5AT: RE5R05A]
SHIFT LOCK SYSTEM
JCDWA0006GB
SHIFT LOCK SYSTEM
TM-173
< COMPONENT DIAGNOSIS >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
JCDWA0007GB
TM-174
< COMPONENT DIAGNOSIS >
[5AT: RE5R05A]
SHIFT LOCK SYSTEM
Component Function Check
INFOID:0000000000957104
1.
CHECK A/T SHIFT LOCK OPERATION
1.
Turn ignition switch ON.
2.
Shift the selector lever to the “P” position.
3.
Attempt to shift the selector lever to any other position with the brake pedal released.
Can the selector lever be shifted to any other position?
JCDWA0008GB
SHIFT LOCK SYSTEM
TM-175
< COMPONENT DIAGNOSIS >
[5AT: RE5R05A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
YES
>> Go to
NO
>> GO TO 2.
2.
CHECK A/T SHIFT LOCK OPERATION
Attempt to shift the selector lever to any other position with the brake pedal depressed.
Can the selector lever be shifted to any other position?
YES
>> INSPECTION END
NO
>> Go to
Diagnosis Procedure
INFOID:0000000000957105
1.
CHECK SELECTOR LEVER POSITION
Check the selector lever position for damage. Refer to
TM-230, "2WD : Inspection and Adjustment"
(2WD),
TM-230, "AWD : Inspection and Adjustment"
(AWD)
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Adjust control linkage. Refer to
TM-230, "2WD : Inspection and Adjustment"
"AWD : Inspection and Adjustment"
(AWD).
2.
CHECK POWER SOURCE
1.
Turn ignition switch OFF.
2.
Disconnect shift lock relay.
3.
Check voltage between shift lock relay harness connector and ground.
Is the inspection result normal?
YES
>> GO TO 7.
NO-1
>> When pressing the brake pedal, the voltage is 0 V.: GO TO 2.
NO-2
>> When releasing the brake pedal, the voltage is battery voltage.: GO TO 5.
3.
CHECK POWER SOURCE
1.
Disconnect stop lamp switch harness connector.
2.
Check voltage between stop lamp switch harness connector and ground.
Is the inspection result normal?
YES
>> GO TO 4.
NO
>>
Check the following. If NG, repair or replace damaged parts.
• 10 A fuse [No. 7, located in the fuse block (J/B)]
• Harness for short or open between battery and stop lamp switch harness connector terminal 1
4.
CHECK STOP LAMP SWITCH
Check stop lamp switch. Refer to
TM-177, "Component Inspection (Stop lamp switch)"
Is the inspection result normal?
YES
>> Repair or replace harness connector between stop lamp switch and shift lock relay.
NO
>> Replace stop lamp switch. Refer to
.
5.
CHECK STOP LAMP SWITCH
(+)
(
−
)
Condition
Voltage (Approx.)
Shift lock relay harness connector
Ground
Connector
Terminal
E52
2
Depressed brake pedal.
Battery voltage
Released brake pedal.
0 V
(+)
(
−
)
Voltage (Approx.)
Stop lamp switch harness connector
Ground
Connector
Terminal
E110
1
Battery voltage
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст