Infiniti G35 (V35) Sedan. Manual — part 334
DEF-58
< ON-VEHICLE MAINTENANCE >
PRE-INSPECTION FOR DIAGNOSTIC
ON-VEHICLE MAINTENANCE
PRE-INSPECTION FOR DIAGNOSTIC
Basic Inspection
INFOID:0000000000962717
BASIC INSPECTION
1.
INSPECTION START
1.
Check the service history.
2.
Check the following parts.
• Fuse/circuit breaker blown.
• Poor connection, open or short circuit of harness connector.
• Battery voltage.
Is the inspection result normal?
YES
>> Inspection end.
NO
>> Repair or replace the malfunctioning parts.
FILAMENT
DEF-59
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
K
M
A
B
DEF
N
O
P
ON-VEHICLE REPAIR
FILAMENT
Inspection and Repair
INFOID:0000000000962718
INSPECTION
1.
When measuring voltage, wrap tin foil around the top of the neg-
ative probe. Then press the foil against the wire with your finger.
2.
Attach probe circuit tester (in Volt range) to middle portion of
each filament.
3.
If a filament is burned out, circuit tester registers 0 or battery
voltage.
4.
To locate burned out point, move probe to left and right along fil-
ament. Test needle will swing abruptly when probe passes the
point.
REPAIR
REPAIR EQUIPMENT
• Conductive silver composition (Dupont No. 4817 or equivalent)
SEL122R
SEL263
SEL265
DEF-60
< ON-VEHICLE REPAIR >
FILAMENT
• Ruler 30 cm (11.8 in) long
• Drawing pen
• Heat gun
• Alcohol
• Cloth
REPAIRING PROCEDURE
1.
Wipe broken heat wire and its surrounding area clean with a
cloth dampened in alcohol.
2.
Apply a small amount of conductive silver composition to tip of
drawing pen.
Shake silver composition container before use.
3.
Place ruler on glass along broken line. Deposit conductive silver
composition on break with drawing pen. Slightly overlap existing
heat wire on both sides [preferably 5 mm (0.20 in)] of the break.
4.
After repair has been completed, check repaired wire for conti-
nuity. This check should be conducted 10 minutes after silver
composition is deposited.
Do not touch repaired area while test is being conducted.
5.
Apply a constant stream of hot air directly to the repaired area
for approximately 20 minutes with a heat gun. A minimum dis-
tance of 3 cm (1.2 in) should be kept between repaired area and
hot air outlet.
If a heat gun is not available, let the repaired area dry for 24
hours.
PIIA0215E
SEL012D
SEL013D
CONDENSER
DEF-61
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
K
M
A
B
DEF
N
O
P
CONDENSER
Exploded View
INFOID:0000000000962719
Removal and Installation
INFOID:0000000000962720
REMOVAL
1.
Remove the rear seat cushion and the rear seat back.
Refer to
SE-105, "Removal and Installation"
.
2.
Remove the rear kickplate, rear wheel well garnish and the rear pillar finisher.
Refer to
INT-13, "Removal and Installation"
3.
Remove bolt (A), and then remove condenser (1) from the vehi-
cle body.
INSTALLATION
Install in the reverse order of removal.
JMLIA0013ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст