Infiniti G35 (V35) Sedan. Manual — part 1167
VEHICLE SECURITY SYSTEM
SEC-23
< FUNCTION DIAGNOSIS >
[INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
SEC
N
O
P
VEHICLE SECURITY SYSTEM
System Diagram
INFOID:0000000000961324
System Description
INFOID:0000000000961325
INPUT/OUTPUT SIGNAL CHART
OPERATION FLOW
SETTING THE VEHICLE SECURITY SYSTEM
Initial Condition
• Ignition switch is in OFF position.
JMKIA0056GB
Switch
Input signal to BCM
BCM system
Actuator
All door switch
Open or close
Vehicle security system
• IPDM E/R
• Head lamp
• Horn
• Security indicator lamp
Trunk room lamp switch
Hood switch
Door key cylinder switch
Lock or unlock
Door lock and unlock switch
Door request switch
Intelligent Key
Lock or unlock
Panic alarm
PIIA1367E
SEC-24
< FUNCTION DIAGNOSIS >
[INTELLIGENT KEY SYSTEM]
VEHICLE SECURITY SYSTEM
Disarmed Phase
• When hood, doors or trunk is open, the vehicle security system is set in the disarmed phase on the assump-
tion that the owner is inside or near the vehicle.
• When the vehicle security system is in the disarmed phase, the security indicator lamp blinks every 2.4 sec-
onds.
Pre-armed Phase and Armed Phase
When the following operation 1 or 2 is performed, the vehicle security system turns into the “pre-armed”
phase. (The security indicator lamp illuminates.)
1.
BCM receives LOCK signal from front door key cylinder switch or Intelligent Key, after hood, trunk and all
doors are closed.
2.
Hood, trunk and all doors are closed after front doors are locked by key or door lock and unlock switch.
The security indicator lamp illuminates for 30 seconds. Then, the system automatically shifts into the
“armed” phase.
CANCELING THE SET VEHICLE SECURITY SYSTEM
When one of the following operations is performed, the armed phase is canceled.
1.
Unlock the doors with the key or Intelligent Key.
2.
Turn ignition switch “ON” or “ACC” position.
CANCELING THE ALARM OPERATION OF THE VEHICLE SECURITY SYSTEM
When unlocking the door with the key or Intelligent Key the alarm operation is canceled.
ACTIVATING THE ALARM OPERATION OF THE VEHICLE SECURITY SYSTEM
Check that the system is in the armed phase. (The security indicator lamp blinks every 2.4 seconds.)
When the following operation 1 or 2 is performed, the system sounds the horns and flashes the headlamps for
about 50 seconds.
1.
Hood, trunk or any door is opened during armed phase.
2.
Disconnecting and connecting the battery connector before canceling armed phase.
PANIC ALARM OPERATION
Intelligent Key system may or may not operate vehicle security system (horn and headlamps) as required.
When the Intelligent Key system is triggered, ground is supplied intermittently to both headlamp relay and horn
relay.
When headlamp relay and horn relay are energized, then power is supplied to headlamps (LH and RH) and
horns (HIGH and LOW).
The headlamp flashes and the horn sounds intermittently.
The alarm automatically turns off after 50 seconds or when BCM receives any signal from Intelligent Key.
Component Parts Location
INFOID:0000000000961326
VEHICLE SECURITY SYSTEM
SEC-25
< FUNCTION DIAGNOSIS >
[INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
SEC
N
O
P
1.
BCM M118, M119, M120, M121, M122,
M123
2.
IPDM E/R E5, E6
3.
Remote keyless entry receiver
M104
4.
Inside key antenna (console) M146
5.
Outside key antenna (rear bumper)
B63
6.
Inside key antenna (trunk room)
B49
7.
Front outside handle LH (request switch)
D13
8.
Front outside handle LH (outside key
antenna) D14
9.
Unified meter and A/C AMP M66,
M67
10. Inside key antenna (instrument center)
M131
11. Trunk lid request switch B304
12. Intelligent Key warning buzzer (en-
gine room) E57
A.
Dash side lower (Passenger side).
B.
Engine room dash panel (RH).
C.
View with instrument assist lower
panel removed.
JMKIA0142GB
SEC-26
< FUNCTION DIAGNOSIS >
[INTELLIGENT KEY SYSTEM]
VEHICLE SECURITY SYSTEM
D.
View with console rear finisher removed. E.
View with rear bumper removed.
F.
View with trunk rear finisher (up-
per) removed.
G.
View of front door LH.
H.
Behind cluster lid C.
I.
View with hood seal assembly re-
moved.
1.
Horn relay E11
2.
ECM M107
3.
Push-button ignition switch M50
4.
Combination meter (Security indica-
tor) M53
5.
Stop lamp switch E110
6.
Steering lock unit M40
7.
Clutch interlock switch E111
8.
ICC brake hold relay E51
9.
Horn (high) E61, E62
10. Horn (low) E69, E70
JMKIA0144GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст