Infiniti I30 (A33). Manual — part 73
Oil Channel
NHAT0122
AAT307
GI
MA
EM
LC
EC
FE
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
OVERHAUL
Oil Channel
AT-289
Locations of Adjusting Shims, Needle
Bearings, Thrust Washers and Snap Rings
NHAT0123
SAT767J
OVERHAUL
Locations of Adjusting Shims, Needle Bearings, Thrust Washers and Snap Rings
AT-290
NHAT0124
SAT008D
1.
Drain ATF through drain plug.
2.
Remove torque converter.
SAT009D
3.
Check torque converter one-way clutch using check tool as
shown at left.
a.
Insert check tool into the groove of bearing support built into
one-way clutch outer race.
b.
When fixing bearing support with check tool, rotate one- way
clutch spline using screwdriver.
c.
Check that inner race rotates clockwise only. If not, replace
torque converter assembly.
SAT768J
4.
Remove A/T fluid charging pipe and fluid cooler tube.
SAT023JA
5.
Set manual shaft to position P.
6.
Remove park/neutral position (PNP) switch.
GI
MA
EM
LC
EC
FE
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
DISASSEMBLY
AT-291
SAT003F
7.
Remove oil pan and oil pan gasket.
I
Do not reuse oil pan bolts.
8.
Check foreign materials in oil pan to help determine causes of
malfunction. If the fluid is very dark, smells burned, or contains
foreign particles, the frictional material (clutches, band) may
need replacement. A tacky film that will not wipe clean indi-
cates varnish build up. Varnish can cause valves, servo, and
clutches to stick and can inhibit pump pressure.
I
If frictional material is detected, replace radiator after
repair of A/T. Refer to LC-17, “Radiator”.
SAT004F
9.
Remove control valve assembly according to the following pro-
cedures.
a.
Remove control valve assembly mounting bolts I, X and
I
.
SAT015D
b.
Remove stopper ring from terminal body.
SAT016D
c.
Push terminal body into transmission case and draw out sole-
noid harness.
DISASSEMBLY
AT-292
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст