Infiniti I30 (A33). Manual — part 70
CAUTION:
I
Install key interlock cable in such a way that it will not be
damaged by sharp bends, twists or interference with adja-
cent parts.
I
After installing key interlock cable to control device, make
sure that casing cap and bracket are firmly secured in
their positions. If casing cap can be removed with an
external load of less than 39.2 N (4.0 kg, 8.8 lb), replace
key interlock cable with new one.
SAT650J
REMOVAL
NHAT0113S01
Unlock slider from adjuster holder and remove rod from cable.
SAT751J
INSTALLATION
NHAT0113S02
1.
Set key interlock cable to steering lock assembly and install
lock plate.
2.
Clamp cable to steering column and fix to control cable with
band.
3.
Set control lever to P position.
SAT752J
4.
Insert rod into adjuster holder.
5.
Install casing cap to bracket.
6.
Move slider in order to fix adjuster holder to rod.
GI
MA
EM
LC
EC
FE
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
A/T SHIFT LOCK SYSTEM
Key Interlock Cable (Cont’d)
AT-277
Control Device
NHAT0262
SAT753J
SHIFT CONTROL SYSTEM
Control Device
AT-278
Control Cable
NHAT0263
SAT754J
GI
MA
EM
LC
EC
FE
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
SHIFT CONTROL SYSTEM
Control Cable
AT-279
SAT031J
Control Valve Assembly and Accumulators
NHAT0114
REMOVAL
NHAT0114S01
1.
Drain ATF from transaxle.
2.
Remove oil pan and gasket.
SAT327F
3.
Disconnect A/T solenoid harness connector.
SAT995C
4.
Remove stopper ring from terminal cord assembly harness
terminal body.
5.
Remove terminal cord assembly harness from transmission
case by pushing on terminal body.
SAT004F
6.
Remove control valve assembly by removing fixing bolts I, X
and
I
.
Bolt length, number and location are shown in the illustration.
I
Be careful not to drop manual valve and servo release
accumulator return spring.
7.
Disassemble and inspect control valve assembly if necessary.
Refer to AT-312.
ON-VEHICLE SERVICE
Control Valve Assembly and Accumulators
AT-280
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст