Infiniti I30 (A33). Manual — part 76
SAT028F
c.
Remove needle bearings from rear planetary carrier assembly.
SAT054D
d.
Check rear planetary carrier, rear sun gear and needle bear-
ings for damage or wear.
e.
Check clearance between pinion washer and rear planetary
carrier with feeler gauge.
Standard clearance:
0.20 - 0.70 mm (0.0079 - 0.0276 in)
Allowable limit:
0.80 mm (0.0315 in)
Replace rear planetary carrier if the clearance exceeds allow-
able limit.
SAT029F
34. Remove rear internal gear and forward clutch hub from trans-
mission case.
SAT030F
35. Remove overrun clutch hub from transmission case.
SAT031F
36. Remove needle bearing from overrun clutch hub and check for
damage or wear.
GI
MA
EM
LC
EC
FE
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
DISASSEMBLY
AT-301
SAT032F
37. Remove forward clutch assembly from transmission case.
SAT033F
38. Remove needle bearing from transmission case.
AAT850
39. Remove output shaft assembly according to the following pro-
cedures.
a.
Remove side cover bolts.
I
Do not mix bolts A and B.
I
Always replace bolts A as they are self-sealing bolts.
SAT434D
b.
Remove side cover by lightly tapping it with a soft hammer.
I
Be careful not to drop output shaft assembly. It might
come out when removing side cover.
SAT440D
c.
Remove adjusting shim.
DISASSEMBLY
AT-302
SAT035F
d.
Remove output shaft assembly.
SAT435D
I
If output shaft assembly came off with side cover, tap cover
with a soft hammer to separate.
SAT036F
e.
Remove needle bearing.
SAT037F
40. Disassemble reduction pinion gear according to the following
procedures.
a.
Set manual shaft to position P to fix idler gear.
b.
Unlock idler gear lock nut using a pin punch.
SAT061D
c.
Remove idler gear lock nut.
I
Do not reuse idler gear lock nut.
GI
MA
EM
LC
EC
FE
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
DISASSEMBLY
AT-303
SAT841DB
d.
Remove idler gear with puller.
SAT916D
e.
Remove reduction pinion gear.
f.
Remove adjusting shim from reduction pinion gear.
SAT039F
41. Remove return spring from parking shaft with screwdriver.
42. Draw out parking shaft and remove parking pawl from trans-
mission case.
43. Check parking pawl and shaft for damage or wear.
SAT066D
44. Remove parking actuator support from transmission case.
45. Check parking actuator support for damage or wear.
SAT040F
46. Remove side oil seal with screwdriver from transmission case.
DISASSEMBLY
AT-304
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст